Efficient CableCreation 100 Pack: Three Piece Transparent Connectors for Seamless Connections Review

I might think that's technical enough, but whoever designed the flat cable insert is a sadist. The insert comes with rails that separate the wires where they should be, but they can come loose very easily when the connection is crimped on the cable. If they were sealed tubes and not half-open rails, then the wires stayed in place. but they are not and never will be. Good luck with those connections from hell. In hindsight they probably need to be left open to allow the full length of wire to be

These things are connectors from hell. Pure garbage. I watch cable TV all the time and bought Fry's Tips before they went out of business. I have purchased other Cable Creations products and have been satisfied, but obviously whoever designed this crap doesn't know anything about sloped cables. I usually have to repeat 1 out of 30 picks due to mistakes on my part. With these tips, I had to repeat each of them 4 to 5 times to get each one right. A 30-minute typing task turned into a 4-hour…

First, note that this is a category 6a RJ45 connector, although it may work with lower (older) category ethernet cables. Secondly, note that I only used one and placed it at the end, which is the ungrounded end that has no shield connected to ground at its end. that I have used. Although the individual wires don't fit tightly into the slider holes, their diameter is closer to the holes than other sliders I've used. As a result, they seem to stay in the slider better when I thread the wires in…