Audi A3 S3 A4 S4 A6 A6L S6 A8 S8 RS4 RS6 Q7 Rear View Camera Review

Works well. Not easy installation on my Audi A4, there is no cable hole in the car. Had to drill one through the number plate light which was a little tricky.

Had to drill in the car. my husband didn't have it. didn't use it. since it requires you to crash into a car. In the end we went non-invasive.

Factory finished. Can be easily installed in the original light plate. You have to drill a hole about an inch in the plastic behind the light, but the camera is nice and looks like it's stock.

Looks good but difficult to apply on A4 2008. A 1/2 inch hole needs to be drilled in the lantern housing. It wasn't mentioned at all in the instructions. Typical Chinese quality. After installation, my car's computer diagnostics detected a bad light bulb in the LED portion of the camera's license plate. Not good. Don't waste time.

Can't beat the price! I gave 4 stars instead of 5 because it didn't fit completely in the hole. The camera isn't the best quality but at least it works, just like the other review said, the camera is facing down. The positive thing is that the LED is not too bright. The camera works, everything you need for a reversing camera is there. As I said, the price is unbeatable! Installed on Audi A4 B6 2005.

It took me 2 hours to install it on my 2002 Audi A4 (B6). I had to drill a big hole in the lantern's body, which wasn't difficult for me. However, the pins in the camera weren't connected properly, so I had to swap the wires (+) and (-) to the connector itself. This required me, after removing the sunroof trim, to disconnect the wire harness that went to the connector. Not happy that I had to rewire the wiring harness myself because the product wiring was done incorrectly at the factory.

Fits as expected with minimal modifications. My car is a 2003 Audi A4 1.8T FWD (B6) which was on the compatibility list. The only mod I had to implement was to drill a hole big enough to go through the ends of the power and video jacks and connect a wire or two and then route them to the main unit. To do this, however, the interior panels must be removed. Otherwise, this unit fits perfectly into the license plate light. I'm not sure why people have complained about anything and here are some…