Header banner
Revain logoHome Page
carbon brushes compatible dreme l rotary logo

Carbon Brushes Compatible Dreme L Rotary Review

3

·

Terrible

Revainrating 1.5 out of 5  
Rating 
1.7
🔩 Power Tool Parts & Accessories, 🔧 Power & Hand Tools

View on AmazonView on ЯM

Media

(1)
img 1 attached to Carbon Brushes Compatible Dreme L Rotary

Description of Carbon Brushes Compatible Dreme L Rotary

Compatible with Dremel Rotary Tool 4000.Size: 6.3x4.8x8.4mm. Step 1: Use the wrench to open the cover of carbon brush. Step 2: Take out the carbon brush. Step 3: Replace with the new carbon brush. Step 4: Use the wrench to lock the cover well. Package Included: 4 x Carbon Brushes.Manual measurement, please allow 0.3 mm error. Because this brush is very small, sometimes it may fall out of the bag, or the number is not right. If you receive the wrong number of carbon brushes, please don't leave a bad comment immediately. Please contact me to return or exchange them. Thank you very much.

Reviews

Global ratings 3
  • 5
    0
  • 4
    0
  • 3
    0
  • 2
    2
  • 1
    1

Type of review

Revainrating 2 out of 5

Not Power Tool Ready Spares

These brushes should fit my Dremel 4000. The carbon brushes were too big. I had to sand them down to make them fit. Only received 3 springs for 4 brushes ordered. The brushes didn't match the nibs, I used old nibs. My instrument worked great. Buy from someone else.

Pros
  • Few competitors
Cons
  • Problems

Revainrating 2 out of 5

Assembly required for power and hand tools

Springs and brushes shipped unconnected. I had to lay down some carbon to make the spring fit. Then there isn't much material for the spring to hold on to. So I added a drop of epoxy to hold them together. Once the epoxy had set I put in the brushes and my Dremel 4000 ran like new.

Pros
  • Easy to read control panel
Cons
  • Almost OK

Revainrating 1 out of 5

Will not fit Dremel 4000

Like most other reviews this one requires assembly. I don't mind, attaching the feathers to the brushes is easy. They will NOT fit the Dremel 4000 HOWEVER. These brushes are larger than the Dremel hub and will not fit inside. The nibs are also much longer and thinner than Dremel brush nibs. Even if the brushes fit, they won't seat properly with these springs. I do not recommend them for Dremel 4000 parts.

Pros
  • Amazing
Cons
  • Vulgarity