🚗 Chevy 6 Lug Chromed Center Cap Hubcap Wheel Cover - OEM 16 Inch, 1999-2011 | 9598133 9598135 9598137 Review

Fits my 13 year old Silverado. I went with no problems. Some people complain that the ears don't curl. Then tighten the opposite side like you're tightening a hoop and that helps. There was a grip that was a bit difficult, a little pressure, and it goes on.

This item did not fit my 2009 Chevy Silverado. Nuts that should be tightened were torn off and didn't fit properly. Don't buy this. A very cheap item. Go through the retailer instead.

So this is the second one I'm ordering as the first one fell off a week after putting it on. So today the new one I ordered fell off, luckily I heard that and was able to pick it up from the street. I don't know why it doesn't hold, I tighten it as tight as I can without breaking it, but it still comes loose.

I installed the center cap and after a day of riding the cap was gone. I don't know when it broke so I couldn't restore it. I installed it securely so I'm not sure why it fell. This issue was reported in another review. I'll try another one and keep an eye on it. If it falls again I will request a refund.

Cases look good and look just like the originals. The nuts were not long enough to engage the tabs. The small protrusions on the back of the lid were cut flush with the rest of the lid and it worked, although another quarter inch would have been better. Apparently the original equipment has the same problem because similar measures have been taken there.

They seem like a good replacement right away, but they don't stay in the car. I bought these to replace damaged ones on my Silverado and have now had to buy another pair to replace the ones I just received. At first I thought it was coincidence - I was lucky enough to find them near where they fell so I reinstalled them safely - but after a few days I noticed they were gone again .

The hat looks good but when I tried to put it on the first and worst came out. Plastic nuts do not attach to metal nuts like the originals. I have found that the body of the part is wider or thicker, nothing allows the part to install enough for the nuts to reach the lug nuts. So basically it's useless unless I can somehow sand down that thick body to make it fit properly. Much luck.