Header banner
Revain logoHome Page
πŸ” maximize quality and precision with climax sda 087 plating adapter length logo

πŸ” Maximize Quality and Precision with Climax SDA 087 Plating Adapter Length Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
🚜 Hydraulic Equipment, 🚰 Hydraulics, Pneumatics & Plumbing

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ” Maximize Quality and Precision with Climax SDA 087 Plating Adapter Length

Description of πŸ” Maximize Quality and Precision with Climax SDA 087 Plating Adapter Length

Provides torque transmision and alignment. Design fully engages the shaft without marring. Easily installed where major disassembly would otherwise be required. Simple way to decrease shaft OD. Black oxide provides some corrosion resistance.

Reviews

Global ratings 3
  • 5
    0
  • 4
    2
  • 3
    0
  • 2
    0
  • 1
    1

Type of review

Revainrating 1 out of 5

Made from cheese on hydraulic equipment

Garbage. Appears with quite a beating. Bent after 10 minutes of actual use. Asked the company for advice, got no response. Don't waste your money on this garbage.

Pros
  • Alright!
Cons
  • Expensive

Revainrating 4 out of 5

. Cutter so I had to file one side like the shaft of tiny motors

Uh so I just assumed the 5/8 shaft was keyed and wanted to use it for a single phase motor, um to make the shaft smaller but it doesn't and I don't have a router so I had to file one side like the shaft of tiny motors. So suck. It works fine but I want it to be with a key, keep that in mind. I'm also sorry if that's not really what this product is for and I'm wrong in assuming it should be listed which is why it got 4 stars instead of 3.

Pros
  • Certified
Cons
  • Cord is shorter than other picks

Revainrating 4 out of 5

Good when folded back

I had to put this in my lathe and bend the shaft to fit my drill chuck. I knew I had to do it so it wasn't a problem. However, I then noticed that the wave had a significant impact. I didn't put an indicator on it but I think it's 1/8" at the top. That's a lot. But since I gave it up it's perfect now and works great for my application. I have 3 clutch bearings in series clamped in it and use it on my honey extractor instead of turning it by hand.

Pros
  • Best in the niche
Cons
  • I'll add later