Header banner
Revain logoHome Page
⚙️ cmt 192 001 11 carbide downcut diameter: efficient and precise cutting power logo

⚙️ CMT 192 001 11 Carbide Downcut Diameter: Efficient and Precise Cutting Power Review

3

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
🪚 Router Bits, 🔪 Cutting Tools

View on AmazonView on ЯM

Media

(2)
img 1 attached to ⚙️ CMT 192 001 11 Carbide Downcut Diameter: Efficient and Precise Cutting Power
img 2 attached to ⚙️ CMT 192 001 11 Carbide Downcut Diameter: Efficient and Precise Cutting Power

Description of ⚙️ CMT 192 001 11 Carbide Downcut Diameter: Efficient and Precise Cutting Power

1/2-Inch Cutting Length, 2 Cutting Edges, Right-Hand Rotation. Premium Quality Solid Carbide, Excellent finish on the workpiece upper side Downward chip ejection. For cutting, copying, sizing and routing wood products, plastic & laminates. For use on machining centers, point to point machines, CNC routers. Also for use on hand-held routers equipped with chucks or adaptors.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Excellent Downcut Router Bit

When I tried this downcut router bit, I was impressed by its clean and accurate cut. The carbide tip stayed sharp even after multiple uses, making it an excellent investment for a variety of projects. The only downside is that it is a bit on the expensive side compared to other router bits in its category. Overall, I would highly recommend this product for its quality and precision.

Pros
  • Clean and accurate cut, carbide tip stays sharp
Cons
  • Expensive compared to other router bits

Revainrating 5 out of 5

Great cutter if you're not clumsy.

Cuts excellently without leaving unsharp edges on veneer. Don't drop it, it will crash. Ouch! I think I need another one.

Pros
  • Also for use on routers fitted with chucks or adapters
Cons
  • Newer model could have been selected

Revainrating 3 out of 5

This is a great bit, not a bit

So this is a solid bit that cuts really well. However, it was advertised as a 10 pack (the stock image has a small image in the top right corner which is misleading). I usually use a few cheaper bits as my machine isn't the stiffest and they aren't usually that hard so are less likely to break (also have extras just in case). However, I think it will help me get the job done. Low rating only because of misleading picture.

Pros
  • For cutting, copying, calibrating and routing wood, plastic and laminate
Cons
  • Crumples