🔪 CMT 529 254 31: High-Precision 32 Inch Cutter Diameter for Optimal Performance Review

I bought two of these because I had about 4000 end caps to cut. Half the way passed and the first boat didn't slow down. I cut kayu batu (Indonesian hardwood) so I'd say the cutter is pretty durable. Unlike some wire cutters, this one doesn't make a beveled end. But the exchange in my case is successful. I can use one of the plugs I cut out to fill 3 or 4 holes. Also, because I use a small belt sander to make a slight bevel on the piston, the bevel can be kept shallow to maximize piston wall…

Wowww. I am amazed at the quality of this beat and the price. He's extremely sharp. And mine came in the original CMT Orange tool kit. I was expecting some free shit. But this bit lasts a while if treated with care. I bought this to make some pocket hole plugs out of the same wood I used for the project. I use the kreg k5 pocket hole master system. When I saw that Kreg was selling a cork cutter for about $80 I thought there must be a way to do without their little piece of plastic accessory…

Purchased to cut red oak corks to hide screws on a wall section of an unfinished 3/4 thick red oak floor. A Lowes candle cutter died after making less than a few dozen candles that were originally oversized. This cutter just keeps going. I've cut a few hundred so far. I found that when I cut out the plugs by cutting through a piece of flooring, I soon had a pile of plugs with shavings on my drill press table. This cutter cuts a giant hole to get a 3/8 inch dowel. It's easier to set the drill…