Header banner
Revain logoHome Page
boost efficiency with the confast inside diameter machine setting logo

Boost Efficiency with the CONFAST Inside Diameter Machine Setting Review

3

·

Very good

Revainrating 4 out of 5  
Rating 
4.0
🔩 Screws, 🔩 Fasteners

View on AmazonView on ЯM

Media

(2)
img 1 attached to Boost Efficiency with the CONFAST Inside Diameter Machine Setting
img 2 attached to Boost Efficiency with the CONFAST Inside Diameter Machine Setting

Description of Boost Efficiency with the CONFAST Inside Diameter Machine Setting

SHALLOW EMBEDMENT OPPORTUITIES-Less time required to drill hole. NATIONAL COARSE THREADS-Bolts and threaded rod is most common type available. INTERNAL THREADS Easy-removabilityWORKS IN MOST MASONRY MATERIAL-Consistent holding values in wide variety of base materials. REQUIRES THE USE OF A SETTING TOOL-Setting tool allows for proper positive expansion of the anchor.

Reviews

Global ratings 3
  • 5
    1
  • 4
    1
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Efficient, economical.

I used these to secure a 5/32" cable in the concrete floor under the tiles. wooden shelving system), they were easy to install and didn't have a single flaw. The included installation tool is efficient and easy to use. I used a large (5/8") diamond hole saw for the tile, then a hammer drill and masonry bit to set the anchors into the concrete below.

Pros
  • Screws
Cons
  • Cable is shorter than other hooks

Revainrating 5 out of 5

Great product when used correctly. good company

When installed correctly this is a great product. Just make sure you're using the correct STEP bit and not a regular 1/2" masonry bit, and don't install it backwards, hammer it in nice and tight. I had a problem with a couple of broken boxes. Most are already compressed and expanded in the box. Revain's return window was closed so I contacted Confast direct and they were very helpful. Good company!

Pros
  • Mounting Screws
Cons
  • Crumpled Packaging

Revainrating 3 out of 5

Little cone in the hole FIRST!

I used the 1/4 and 1/2 combination drill bit used for shutters to drill a hole for them. They're sitting pretty tight. The combination drill has a stopper so you get the perfect drill depth every time. If you're using a regular 1/2 masonry bit, your hole is likely to be a bit larger and the anchors won't go in as firmly as with a combination bit. I live in Florida and have combo beats at my local store, but I'm pretty sure Revane has them too. Another piece of advice. They CAN be used in hollow

Pros
  • Industrial & Scientific
Cons
  • Crumpled