🔩 Enhanced Performance with Cortex Traditional Screws Lineal Smooth Review

Very nice because the screws manage to cut a perfectly clean hole for the dowels. It's faster and easier than using a drill. I'm almost disappointed with how easy the whole setup is, because what did I just spend thirty bucks on? in end caps (preferably with a rubber mallet. Azek finishes are double-sided. Frontier is the side that looks like rough wood and the traditional side is the flat side. Dirty paint is leveled out. For a porch, the grain is correct, but I believe not that they make end…

You can't beat this beautiful system for neatly hiding the screws that attach the new PVC paneling to our windows in our house and garage. This is a wonderful way. 11/16" x 2 3/4" plated screws. Each box comes with an installation tool which is a #1 square hex bit (with 1/4 inch thick felt pad to avoid scratching the surface) which drives/countersinks the screw to the correct depth . If you're careful, the installation tool usually goes through the end of the box. The screws are sharp and…

I loved these screws. Over the years I have used them successfully in many different finishing materials. Including unbranded PVC, Miratec and LP Smartside. This style is different. They are 2 inches shorter than 2-3/4 inches and have more neck cords just below the head. More than half of them don't sit down and start spinning in the hole. Not only does this prevent you from using the fork, it also doesn't tighten the skin. I use boards that are 1" thick (actually 3/4") and go in 2x6 pine or…