🔌 Creative Hobbies SPLUG Pack of 5: Easy Snap On End Plug for SPT-1 Wire, 8A, 125V, Residential Grade, Non-Grounding, White Review

These connectors are designed for very thin #18 wires and specifically lightning cables. They work by cutting the end of the cable, pressing the end into a pocket at the end of the connector body, and then pressing the cable against metal pins that pierce the insulation and connect to the conductors. There is a very strong lid that works great. This is a good system if you have the right type of zipper. After two out of three failed to connect to the #18 cable I was using, I threw away the…

I needed a low profile electrical plug that would allow the cord to be routed close to the wall. For some reason the hardware store didn't have them, but Revane did. They were just a little tight at 18 gauge. I had a zip cord that seemed to have a little thicker insulation than some. This made the connector harder to connect than I had hoped, but it worked. Because of the way they're assembled, you'll need to take extra care to cut the cable properly so the conductors don't short out, but with…

I needed a connector with a very compact form factor. We have a conditioner in the bathroom and there is very little space on the countertop. The dental floss we use comes with a standard (long) cord. The distance from the block to the outlet is about 7 inches. This meant the twisted cord just sat there, taking up space, and just looking "unkempt". I stumbled across these and as the power cord was small I figured they would fit. You did great. I shortened the power cord to 7 inches and…