🔩 Cruiser Accessories 82050 Screw Covers in Sleek Black - Enhance Your Vehicle's Aesthetic Appeal Review

Bought a thin red line and four screws for fastening. So far, so good. Then when it comes time to attach the black screw covers, things don't fit over the screws. The ad does not include dimensions. I ended up screwing it up.

Claimed to be for universal use but didn't work with my standard sized socket screws until I hammered them in. I'm definitely not going to take the screws out without cutting them apart. Otherwise they still work as intended.

The screws I had didn't quite match these caps. They must contain screws if a specific type is required for their use. The heads were too thick and the plastic just bent at an angle and the lids didn't sit flush or hold up at all.

I was recently looking at license plate covers at Revain and in the 'Frequently Bought Together' section there were screws and these screw caps to add to my cart. I figured why not and added these two extra items to my original license plate cover. When the caps arrived I could tell that they were of poor quality and did not match the screws that came with them. I prefer not to use them at all.

They do not fit number plate screws for attaching number plates, frames and covers to domestic cars and trucks (Black Zinc Plated) which Revain believe are often purchased together, the cap quality leaves much to my opinion to be desired, not worth the money, the tops were scuffed so the glossy finish didn't look right anymore and overall it looked worse than just leaving plain screws. I would recommend just sticking with the screw type unless you have pan head screws.

Terrible, terrible, cases. I ordered these at the same time as another set of caps that came with new black powder coated plates. These lids don't hold up like the other set I bought. They just sit on the screw, don't snap into place. One fell off after 2 days of driving. These covers are NOT UNIVERSAL. If the screw on your panel has a rounded tip that is larger than 1/2 inch, it will not fit properly. Unfortunately, I should have read more negative reviews before purchasing. I have tried them…

BENEFITS: • Goes well with Rightcar Solutions' legacy CA license plate and black silicone frame • Aesthetically pleasing, gives a sleek look • Deters would-be thieves from stealing your license plate • Installation was easy and quick • Screw caps snap securely in place CONS: • All 4 plastic plugs had extra plastic moldings that had to be scraped off • It is difficult to remove the plugs after installation on the side of the plate while the screws are in the rim • It is recommended to use…

I have received several kits (4) to cover the heads of the front and rear license plate screws and have mostly had good results with these covers. I was looking at a separate kit that came with screws and threaded plastic fasteners for your bumper, but it wasn't directly about covers (I guess who remembers?). These covers and the clear plastic rings that hold the covers in place are easy to install, with one exception: the holes in the clear plastic rings are almost always slightly larger than…