CUSTOM Electric Intank Fuel Pumps & Complete Installation Kit E8213 Review

The engine only runs at idle but the engine will not run at high RPM. The fuel pump is not delivering the right amount. will not work

I need to rewire the connector to fit the fuel pump module. Also remember to attach the rubber cover before attaching the locks. But it works very well.

2000 Honda Accord universal fuel pump beautifully packaged. It would be great if it came with OEM electrical connectors. But it works fine. So far, so good.

I want to replace these I installed this pump and only worked about a week. Pump for a second and then stop, thanks. I don't know if other people have problems with the product, they would like to try a different one

I checked the car for a pump and was told it would fit. However: 1. The length of the pump is a few cm shorter than the standard pump2. The base does not fit the old pump's rubber foot - the rubber boot that came with the pump is not for the Miata. However, the pump works on the car, it just doesn't fit. At the moment I can use it to start the car in the garage and start the engine.

I have a 2001 Toyota Sequoia with 235,000 miles on it. I don't know if the fuel pump was replaced before I received it. Front and rear air conditioning at the same time, the truck lost power and stalled. I bought this pump, it works great, no more shaking and stalling! While this review exists, it did not disappoint. Will update if I have any problems.

Can't comment on durability as I only installed it a few weeks ago. But since then the car has run perfectly. Seems to be a pretty powerful pump. I used this in a 1998 Ford Escort. I couldn't use the new filter on my car model, it was too big to fit in the pump housing so I used the original filter screen. I also used my original cable connector which I had to modify a bit to fit this pump motor. But I'm not complaining about the price. Inflates and holds pressure. Certainly better than buying…

The only real problem I had with this fuel pump was that the rubber mount that came with the bottom of the pump motor didn't have the rubber tabs in the right place around the bearing mount to mount. To mount this fuel pump I had to drill additional holes in the stock fuel pump bracket, grind the raised portion of the punched hole in the bracket and cut off one of the rubber tabs on the included rubber bracket. The tabs must go through the holes in the bracket to prevent the pump from rotating…