BW Cylinder Holders 6.5-7.25 Inch - 1 Unit Review

Perfect for my Dry Nitro 60 cylinder. Easy to install in the van. There were no screws, nuts or washers included. difficult conditions.

I use this in my jeep to hold a can of carbon dioxide to inflate the tires. It's absolutely perfect. Great quality and arrived on time

Good price and good quality. I bought two, one for my MIG welder and welding cart and the second for my TIG welder and wall tank. There are no problems with fasteners.

I installed it on a small section of wall between cars in a separate garage. So I attached an extra piece of wood to the wall overlapping the studs. I used two brackets, but one would probably be fine if placed on top.

This item is well made and holds the tank on my Harbor Cargo Cart better than the chain that came with the cart. Good price, only downside is the Premier had to pay $10 for shipping. But the delivery was fast. Would buy again.

I bought this because my argon hose from my welder was touching my argon tank and I was concerned about damaging it. It has an offset of 2″ 5/8″ and solves the problem perfectly. Now for the quality. I was expecting a cheap thin strap but was pleasantly surprised when this very strong and durable device arrived today. A very well made decision.

Bought this to fit an argon tank on my Harbor Freight welding truck. It worked great. The Port Freight Welding Cart has a sloping rear wall that this clamp must be attached to. You need to build lower mounts with washers to make it perpendicular to the world and hold your bottle. I think I had 3 to 4 washers and fasteners which is nothing. It's better than just using the chains that came with the cart. This bottle won't move until I let go of it.