🔥 High-Performance DeatschWerks 255 LPH In-Tank Fuel Pump with Installation Kit - Guaranteed Efficiency and Easy Set-Up Review

I read that it was a relatively quiet pump so chose it over others. it seems very quiet and i was able to adapt it to my car. It's not a direct replacement, but close enough. that works quite well.

Replace Walbro 255 with DW200 Perfect fit. DW has made a name for itself. If you're looking for top-of-the-line equipment, you've found it. can't beat the price. I use a 1000cc injector. See at 65 lbs 10 lbs boost. For the dw200, this is an easy task and very quiet.

replaced the noisy walbro, heard it through the exhaust, with a new walbro that was even louder at the end. Stumbled across web forums trying to mute audio and someone recommended this device. after the first premiere i never hear this pump

I fitted this pump to my 1992 Corvette and the car starts up better straight away. I like that there is a 3 year guarantee. Its very good quality. This car has stood still for a very long time, it has only 31,000 miles, cobwebs underfoot, mice got in, caused minor damage.

Installation was easy. The pump is the same as the factory pump, only smaller, so it will fit less into the encoder assembly, but will not cause any functional problems. Desolder the old power and ground wires and solder the new pump pigtail to make it look factory like. Quieter than the original ka pump. Noticeable increase in engine performance and response. Mandatory upgrade for SR swaps. I highly recommend this pump.

Perfect fit. Note. The leg on my fuel pump mount had to be cut to make room for the toe of the new pump. The leg of this pump accelerates 180 degrees from the standard pump. It's okay, I returned immediately, even with a sock in a mirrored place. My car now has an oily idle and pulls as it should. The pump is noticeable with the rear seat removed, but not enough to draw attention to it.

I bought this pump because a few people I know said it was a lot quieter than my Walbro 255 pump. In fact I can barely hear it when I turn the key and the pump pump. The connection on this pump is the same as the connection on the Walbro, but they are not interchangeable. However, this pump came with a new plug and was easy to replace. To watch an installation video, search Projectgattago on Youtube.

I ran across this little guy looking for a solution to a tank problem on an '86 Volvo 245 that I picked up and modified for a Gambler 500. The stock fuel system uses two pumps. , one inside and one outside the fuel tank to supply fuel. My pump in the tank failed and the load was shifted to an external pump. I had my doubts about going to a single in-tank pump, but this thing delivered everything it had. I'd say we put in over 500 miles on our trek, and the only fuel system issues I had after…