Denso 6716262 671 6262 Wire Set Review

They were regular wires, they fit well but they work. I will probably exchange them again for better and more suitable wires for my 07 JKU.

Old cables were original Mopar. The resistance measured on the shortest wire (#2) was over 1kΩ for about 10 inches. The new cable for the same cylinder was 80 ohms. Huge improvement. Ideal for JK 3.8. Came ready to install with all the correct thermal guards and boot lube. Would definitely buy again.

The original cables were from Mopar and after 80,000 they were in urgent need of replacement. They arrived quickly and well packaged. The length of the wires also fully corresponds to the original. Have driven about 5000 km, no problems. Just make sure they are routed correctly and are not lying next to the driver's side exhaust manifold. Thank you Denso!

Good product. Just like OE on my 2011 Jeep Wrangler. I'm tired of Revain selling used auto parts. This is the third time I have received a previously installed part. Check out my posted photos of a pair of coil ends that already had tuning grease on them. Unfortunately I had already removed the old ones and damaged a few in the process and had no choice but to use these.

These cables are terrible, 3 months and 1000 miles, the engine skips 4 and 6. Come and find out the new cables can't stand the heat generated by the engine off-road on the beach . . Miles on a lonely surf beach and engine swamp, misfires, loss of power. Not a good feeling, especially once I identified the cause. Correction, never buy those poor quality Denso wires again, my 428F rated ass is even close!