Distressed American Flag Old Glory Grunge Look Patriotic Decal Auto Car Truck Hood Side Door Wall Window Toolbox Bumper Vinyl Sticker (Eagle Black) Review

This is a beautiful striped set. For $13 you are NOT getting the best pre-mask, so I highly recommend applying it with an application solution (water and dish soap in a spray bottle). I used the solution applied and had very few problems, waaaaay it's easier to place a sticker. I can't imagine doing without it!

They stick well and are easy to apply. The graphics were not the same as in the picture. perhaps one could get closer to it by manipulating every little bit of the sticker. but instead I just used it to make this cool tread pattern. If you have a good extra leg, you can trim it to the length you want as needed.

Very good quality decal also at a great price. Installation is not easy as each decal/vinyl requires a certain level of expertise. I recommend patience, a 90/soap 10 solution of water, a hair dryer or blow dryer, a credit card or similar to remove bubbles, a razor blade or scalpel to remove cuts or bubbles, and use painter's tape to mark the position of the sticker. However, a YouTube tutorial is always a good choice.

This decal looks great on the hood of my 2003 Dodge Estate, it really brings the front of the car to life. The application process was a bit tricky as the pointed parts of the eagle didn't want to peel off the plastic that easily so I had to peel it off, but the top layer of plastic came off easier after the sticker was placed on the case. wiper machine. There were air bubbles in the vinyl, but the ones I couldn't remove I removed with an X-Acto knife. We'll just have to wait and see how long…

They look great when you put them on, but damn it's some work. They arrived crumpled and the clear top layer bubbled profusely. I warmed them up with a hair dryer and then laid them on the floor with the books overnight. This helped a lot, but the top coat caused problems when applying as the decal was wrinkled due to bubbles between it and the clear coat. It wasn't perfect, but it turned out pretty good with a lot of patience and hard work. However, the final look is fantastic. UPDATE: On my…

Although the app was quite tedious, it didn't result in any product quality errors. First we cut the two sides to separate them and cut off part of the front wing. We then used a hair dryer to heat the decal and make it as flat as possible since it was rolled up in the packaging. Flattening the blisters was painful, but not impossible. We used a utility knife to remove the stickers crossing the doors and excess leftovers. No use solution or anything chemical, just rinse off the standard water…