Header banner
Revain logoHome Page
dorman 902-805 water pump mounting hardware, black logo

Dorman 902-805 Water Pump Mounting Hardware, Black Review

4

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🌡️ Engine Cooling & Climate Control, 🛠️ Replacement Parts

View on AmazonView on ЯM

Media

(2)
img 1 attached to Dorman 902-805 Water Pump Mounting Hardware, Black
img 2 attached to Dorman 902-805 Water Pump Mounting Hardware, Black

Details

BrandDorman
MaterialAlloy Steel
Item Weight0.75 Pounds
Vehicle Service TypeATV, UTV, Truck, Passenger car, Van

Description of Dorman 902-805 Water Pump Mounting Hardware, Black

Comes with all necessary hardware to complete the repair. Rust-resistant. Direct replacement for a proper fit every time. Easy installation.

Reviews

Global ratings 4
  • 5
    3
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 5 out of 5

A small prize for a job well done

Good replacement bolts for a 1998 Dodge Durango 5.2 liter water pump. Comes with blue screw lock so they are ready to use. Bolted to spec and had no problems. Would definitely recommend to a friend.

Pros
  • Big prize
Cons
  • Crumpled packaging

Revainrating 5 out of 5

It fits my 1999 Dodge Durango SLT 5.9L 4x4

I bought this for my 1999 Dodge Durango SLT 5.9L 4x4 and it fits perfectly and works just as well as it did when it was new. I've had no problems with it and would highly recommend it for my engine, can't speak for other engines but as for the part itself it's great!

Pros
  • Dope 🔥
Cons
  • Appearance

Revainrating 5 out of 5

The timing chain cover and water pump bolts are great though.

Do not order for engines from other manufacturers. You will not fit. Otherwise they are great for Magnum 5.2 and 5.9 liter V8s. They are the correct length for the Dodge "Magnum 5.2L and 5.9L" but "NOT" for the older 273, 318, 340, or 360 models. Newer Magnum water pumps have screw bosses about 1/2 inch shorter. These bolts are too short to thread into the block on my 1978 Dodge 360. Do not order them for engines other than Magnum. You will not fit. Otherwise they are great for Magnum 5.2 and…

Pros
  • Absolutely amazing!
Cons
  • Discontinued model

Two of these bolt heads broke when tightened, although I used a good torque wrench and their torque did not exceed the maximum range. I think I got a bad batch. I ended up using the original water pump bolts after cleaning them up a bit. The difference between the two screws was obvious! As I tightened the new bolts, I could feel them flexing as they were tightened. I didn't notice that when I reused the existing screws.

Pros
  • Pleasant to use
Cons
  • Very expensive