Dorman 924-228: Front Brake Dust Shield for Dodge Models - Enhanced Performance and Protection Review

Great product at an unbeatable price. Great replacement for the dust cover on my 2003 Dodge 3500 4WD. As in the original, there is a connector for the ABS sensor. Look at the photos where I compare them next to the old dust cover. They are also powder coated (unlike the original) and come with a lifetime guarantee - see photo.

Top quality product but it doesn't fit my 1998 Dodge Ram 2500 with Dana 60 (my fault is overlapping part numbers from another site). Has an extra tab that prevents them from sitting flush. Must have for the newer Ram style. Still better than my old shredded ones and I will change them to make them work. You could either bend the tongue or cut it off about a third more than if I went to the parts store.

I confirm they will work on 2nd gen trucks. I have a 2001 Diesel A 4wd 4wheel abs with a Dana 60 front axle and they worked great without any modifications. I'm not sure why they list the earliest year as 2003 because I can confirm they are working on 2001. Very happy with them. I'm not sure either, but I had two failed ABS sensors after ripping off the old rusty ones. I suspect they are needed to keep the heat in the rotors from damaging the sensors. I highly recommend putting them on and not…

I've been looking everywhere for dust covers for my 2002 Dodge 2500. You can find NOS but they cost about $50 each which is plagiarism. I wrote to the company that makes them and asked if they would work on 2002 and they said no. Others said they worked for 2002 and I took a chance and ordered them and they fitted perfectly. The shield is about 1/2 inch taller, but that's not a problem. My truck has a Dana 60 front end. I don't know why they tell you they don't work on previous trucks, but here

Easy install on 2006 Ram 2500. I have a recommendation. I noticed that the gap the sensor goes through was very sharp. After installing new wheel bearings and ABS sensors, my ABS light came on after 1 day. I checked the sensor and it had a cut due to the sharp edge of the anti-dust slot. This shorted out the sensor and turned on my light. I went to an auto parts store and bought a high temperature gasket and applied it to both the cut and this sharp edge. Allow to dry, reset ABS bulb. After 3…