Header banner
Revain logoHome Page
πŸ” high-precision drill bit: drill america mmo1 32 4fse polished - ideal for accurate drilling logo

πŸ” High-Precision Drill Bit: Drill America MMO1 32 4FSE Polished - Ideal for Accurate Drilling Review

3

Β·

Very good

Revainrating 4 out of 5Β Β 
RatingΒ 
4.0
πŸͺš Router Bits, πŸ”ͺ Cutting Tools

View on AmazonView on Π―M

Media

(2)
img 1 attached to πŸ” High-Precision Drill Bit: Drill America MMO1 32 4FSE Polished - Ideal for Accurate Drilling
img 2 attached to πŸ” High-Precision Drill Bit: Drill America MMO1 32 4FSE Polished - Ideal for Accurate Drilling

Description of πŸ” High-Precision Drill Bit: Drill America MMO1 32 4FSE Polished - Ideal for Accurate Drilling

Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but are more brittle and must be used with rigid toolholding systems. Available in polished finish. Round shanks allow use with a wide variety of toolholding systems. When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging. 4 Flute single end.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    0
  • 2
    1
  • 1
    0

Type of review

Revainrating 2 out of 5

Pretty disappointed in this end mill

Pretty disappointed in this end mill. I was engraving on a flat sheet of 6061 aluminum and it broke after about 7 minutes of starting work. I didn't think I was going very fast, the spindle was running at 10,000 rpm, 14 ipm feed and 0.002 documents. For some reason it just came out. I used lube and air to get rid of the tiny shavings but it still broke.

Pros
  • Straight, Spiral & Trim Bits
Cons
  • Expensive

Revainrating 5 out of 5

Just the right size for Category 5 with rubber plug

It's hard to find a 3/16 inch long end mill or a shank with the same diameter as the cutting face. That fits the bill. We have a selection of these tools for cutting round holes in rubber stoppers about 1 inch thick. Regular drill bits aren't designed to cut through the sidewalls of the rubber, so they just push it aside leaving a very rough cut. End mills work much better and this one is perfect for small 3/16" holes.

Pros
  • Power Tool Parts and Accessories
Cons
  • I'll write later

Revainrating 5 out of 5

Ideal for milling FR1 circuit boards.

Wow, who knew what a difference you could make just by changing the end mill. I have always used the ones supplied by The Other Machine Co with my OtherMill and just assumed deburring the plate with steel wool after cutting was a necessary step. Although this bit was expensive compared to others, I ordered it from Revain simply because it would come quicker. I put it in the machine and cut my first board and I was surprised to find NO EARS. Copper edges are perfect. This photo shows the panel…

Pros
  • Milling Cutter
Cons
  • Unsure