🔴 EAG D-Ring Shackles with Mount, Red D-Rings, Black Isolators, and Mount Brackets, Pair Review

Really amazing and easy to install. Be sure to use heavy duty screws. Amazing value for money D-rings and mounting plate together.

Appears to be a well made product. Mounts to the Jeep TJ factory bumper to match the frame rails. The only complaint I have is the crumpled finish that peels right out of the box.

Fits my 92 F150. It didn't hurt too much, except that the new bit broke at the first hole. Hella is cheaper than $1,000 bumpers, especially since I really only want restraints. I can buy another pair for my back.

There are high performance products. Bought these for the front bumper to attach straps for my canoe. Supplied with 2 sets but without screws and nuts. Heavy duty black bolts/nuts used. I had to remove the plastic plugs on the bumper (with an allen wrench) to get access to the nuts behind the bumper. It took 30 minutes to drill holes and install. Very good. I will order another set/pair for the rear bumper. But you won't regret them. You look cool too lol

I bought these to build the bumper for the F350 4X4 winch due to the weight of the truck. Slotted holes are larger than 1/2" but smaller than 5/8". I have to drill them to accommodate my 5/8" bolts or buy a metric size that fits snugly. This also ruins the powder coating in slotted bolt hole As mentioned in the description they don't fit with mounting hardware. I appreciate the extra Work on my part given their cost not as far as durability time will tell but they seem to be durable time will…

I bought two sets of these staples. The first set didn't last when I had to use them. The welds between the bracket and the steel plate have come loose. On inspection, the welds had ZERO penetration. I think that's completely inadequate. The second set held up much better, but the plate is too thin for the advertised weight and, depending on the mount, flexed so much that I felt unsafe. I had to cut the bracket off the plate and weld it to the new 1/2" plate in several passes. If you don't…

I bought these to fit on the front bumper of my AEV after the factory tins were removed. Out of the box the mounts looked great and very muscular. I was actually going to give them 5 stars but the powder color let me down. During installation, when tightening the mounting screws, the powder paint began to crack and then peel off. This happened around 4 of the 8 bolt holes. One was quite significant and appeared to be the result of poor preparation prior to powder coating. BY THE WAY. . . I had…