Enhanced EasyHeat 10802 Freeze-Free Cable Connector Kit Review

Easily connects to existing wiring. Cable splices that have stainless steel around the wire should not be used with flat black cable systems. I will buy another device in combination with this one: this system is always on when you plug it in. However, gentle heat allows a thermostatically controlled outlet to be used in conjunction with this unit to save energy and conserve the system when not in use. .

East used to install heaters on my van. I bought a 100ft Easy Heat 2102 cable from him. No problems wrapping and insulating my typical van plumbing. Doesn't get too hot and that's the main reason I chose the lower wattage cable. It's pretty easy to cut the cable and plug in this power supply. I've used Knipex knives, but any decent knife should work just fine. I turn the Easy Heat system on and off with a Johnson Controls thermostat. Too much, but I know it will go on.

Easy test assembly: Assemble according to the instructions. NOTE: The cable that goes into the orange adapter must have a YELLOW outer sleeve when you removed it. The yellow outer sheath to get to the black core wire doesn't work. With the YELLOW sheath inserted and the 2 screws tightened, use an ohmmeter to measure the resistance between the 2 screws you just tightened, the resistance will vary (3000-400 ohms) depending on the length of the cable. Check between each screw and the end of the AC