🔧 Elf Bee 310-197 Engine Fuel Injector Removal Tool for Land Rover 5.0 Range and Jaguar 3.0 Review

Great product I think they improved it! I had no problems like the other reviews! Fell off in a few punches! Better than damaging the injectors!

Was a little worried about getting the injectors out. I let them soak in the PB blaster for a few days, but each FI pulled out about 5 slides. Angel was a must. There are no quality problems. (2010 Range Rover Sport 5L)

This tool saves a lot of time when used properly. If the mechanism was tighter on the rim of the injector this would be a great tool. it doesn't sit tight enough on the nozzle causing it to slip off and the rim on the tool holding the nozzle to wear out and no longer stay in place.

The tool will definitely get the job done. The only downside is how the tool is attached to the injector. For best results, always push the locking clip lightly while using the slide hammer to loosen the injector. If this does not happen, the tool slips off. Once I figured it out, it worked great.

very poor quality. on the nozzles loosened, to use the lock had to be held tight, the edges on the nozzle holder curled up after 20-30 hits. The nut on the end of the slider came loose while using the tool. The hammer clasp was poorly machined - not even. I couldn't remove any of the nozzles and had to purchase a higher quality tool to complete the job. All jets are easy to remove with a better tool. Don't waste your time with this tool.

tool I get on Sunday, order on Friday. Tool the only thing you can do and not because the tool is bad it's just for more accuracy put rubber bands on the top of the cylinder which fix the tool and press the bands onto the cylinder after you have no nozzle blockage. You will lose after a few hits, as is the case with the first 5 starts