Enhance Your Vehicle'S Performance With 6X5.5 Hubcentric Wheel Spacers And Lug Nuts For Tacoma, 4Runner, Tundra, And More Review

So I ended up purchasing these for a 2021 Lexus GX 460, and it worked awesome. I think in hindsight I would’ve gone with 1.5 inches instead of 1.25 inches. But I think it looks fine, The stance looks appropriate now. Please see the pictures for before and after. I took it for a drive immediately afterwards and everything ran very smooth, just like stock. Install was super easy, I did have to purchase a torque wrench to torque to the specifications of the vehicle which was 103 pounds.

Very well packaged, seems to be great quality and workmanship. Precise milling. The only concern I had was that the lugs that go into the spacer seemed to "miss out” on a lot of threads, not the lug or spacers fault, it’s the factory stud, it would be even more reassuring if they were longer and the lug had more threads to grab. But, they did get probably 8 rounds on each so with that, the red locktite, and the very close tolerance of the hub I think they’ll be ok.

Easy installation, perfect size. Glad it comes with lock tight for that extra assurance. The front will have a few less threads to hold onto but it’s still got plenty on there! 10/10

These fit Toyota hubs absolutely perfectly. And the ET style lugs they come with center the spacer absolutely perfectly with next to no effort. Pretty damn nice for the money.

Iv seen alot of cheap bad quality spacers. With that said, these really impressed me. Very beefy and good quality. Definitely recommend

Perfect fitment on my 1997 Toyota tacoma 4w drive easy installation and the product does fit on 4wd front manual lock hubs

I put it on my ‘12 tacoma. Torqued the spacer and wheel with a torque wrench to spec and there was a clicking sound as I drove. Took the spacer off and replaced it with BORA spacers. Clicking went away. Figured out that the studs on the spacers was not fully seated! Could’ve killed somebody! I WOULD LIKE MY MONEY BACK

I am pretty happy with the quality. Made a noticeable difference without over doing it. Would definitely recommend to anyone looking for spacers.

I torqued these to spec and used thread locker when I installed these and have had zero issues 1000s of miles later. The threads don’t fit since Toyota make a smaller lug. It’s going to destroy your car don’t buy.

Had to seat a couple of the studs as there were not all pushed in all the way. Other than that they work perfectly for my 4Runner.

I got the result that I myself was looking for. I’ve heard that these have failed and been troublesome in the past but I’m sure that it was do to the installation of the product.Follow the torque specs and it will be fine. If you don’t have an actual torque wrench, don’t try installing these.