🔥 Ewigkeit Heater Cartridge Ceramic Printer: Efficient Heating for High-Performance Printing Review

The wires on this component are about 8 inches shorter than the stock wires that came with my Ender 3, but they still get the job done. If you are replacing one in your Ender 3, expect the other wires in the harness to be significantly longer. Simply connect the ends of all wires flush and slide the excess back into the wire manager before using the zip tie or zip tie. The rest works great!

Don't settle for the difference in resistance between these things. My 5 pack was somewhere between 13 ohms and 15 ohms. With a supply voltage of 24 V, that's between 38 and 44 watts. I'm pretty satisfied. The diameter ranged from 5.88 to 5.95 mm. I use boron nitride paste for routing and gap filling so I don't mind the extra spacing either. Think about it like this. Even if only 2 of these are usable, it will still be a decent value.

The original cartridge heater they replaced had much thicker wire (less wire loss) and thicker insulation (mostly useful for durability as it wasn't lots of electrics gives insulation). required at 24v) but the very nice original extruder heater died after ten hours while this replacement still works after a few hundred hours. The Savoy SV-01 3D printer requires a longer cable, but I connected it to the original heater. Cables come with quick connectors so I don't have to reach into the…