🔌 OREI 1x4 HDMI Extender Splitter: High Definition CAT6/7 1080P Over Single Cable - Long Range - IR Remote & EDID Management - Loop Out - Low Latency Review

Great device - works perfectly. Crystal clear image. We use it to provide an NVR/security camera view from multiple locations in the building and have had no problems. Of particular value is that the endpoints use built-in POE - no AC adapters are required.

This product was great and the customer service was even better. I had some trouble removing videos, but after troubleshooting it turned out to be a setting on my Xbox. OREI's customer service was very responsive, which is perfect for any product these days, especially online orders. I would highly recommend this product and company if you are on the fence.

using it from an audio room laptop to 4 TVs in our auditorium to stream hymns, sermon presentations, video presentations etc. The hardest part was routing the CAT5 -cables that we use. Setting up the system after laying the cable only takes a few minutes. It works flawlessly and streams videos to all TVs without hesitation. would definitely recommend this system.

Use this HDMI splitter to connect (4) 75 inch TVs in a church instead of projectors. 2 TVs at 100ft and 2 at 150ft Category 6. Great picture and sound for the most part. One of the farthest TVs has an intermittent flickering from what appears to be a zeppelin when transmitting a signal. Agree, this is right on the edge of the 50m spec. Try tweaking the EDID to see if that fixes it.

The pictures on Amazon do not match what you are getting, they must have improved the design and haven't updated the pictures yet which is a plus because they are POE so they don't need a power supply on each receiver, the receivers get their power from the power cord to the base unit, that eliminated 8 power distributors and a bit more work I did I had everything turned on. about a day so far so good.

This worked perfectly for me I have 3 TVs in my basement and they are all visible at the same time. I didn't want a delay between TVs because that doesn't appeal to me. I plugged it in and thought wow they're in pretty good sync. So good, in fact, that when I turned up the volume on all the TVs, the audio synced up too. I wasn't expecting it at all, not that I would ever use it like that, but it showed me that there is no lag. 2 runs of 75ft Cat6 for 2 TVs and 1ft for a 3rd TV and still no…

This worked perfectly for me I have 3 TVs in my basement that are viewable at the same time. I didn't want a lag between TVs because it doesn't. I like it. I hooked this up and found they synced up pretty well. So good, in fact, that when I turned up the volume on all the TVs, the audio synced up too. I wasn't expecting it at all, not that I would ever use it like that, but it showed me that there is no lag. 2 runs of 75ft Cat6 for 2 TVs and 1ft for a 3rd TV and still no difference.

I was looking for an alternative way to extend our ProPresenter setup to multiple screens in our lobby and it worked beautifully! I ran into a problem when I had 2 power strips plugged in. After troubleshooting, I found that toggling some small switches on the receiving boxes would solve the problem I was having. So far they're working great! If I didn't have to buy a scissor lift to replace our other system, I would definitely switch to this one.

We use this (or at least try) for monitoring 8 screens. No cable is longer than 100 feet. Also, there is no signal from the device on the TV. The receiver lights up like it has power, but there is no data. There were no instructions in the box and if you look at the company's website there is no information (check their FAQ section if you want a laugh). We use this type of extension cords all the time for customers, but this is the first and last time we try this brand. After playing around…