🎮 eXtremeRate Caution Yellow Repair ABXY D-pad ZR ZL L R Keys for Nintendo Switch Pro Controller - DIY Replacement Full Set Buttons, Tools Included (Controller Not Included) Review

These knobs feel great and look fantastic. They fit well and give the controller a custom look. I wouldn't say they have huge functionality to upgrade, but if you're looking for something to jazz up your controller, great! IMPORTANT: They require a little electronics experience to install. Don't buy them if you are afraid of ribbon cables. That being said, you may need to use a utility knife to cut small plastic pits out of the buttons so they fit perfectly.

I was so excited to get the eXtremeRate buttons in the mail because I really wanted to spice up my controller. One of the things I really liked is that it comes with two screwdrivers to open the controller. Installing the buttons is very easy as they are almost identically shaped. They are soft to the touch. The keys are not as loud and "clicky" as the original. One problem I had was that the "A" button sometimes got stuck. Over time you will have to grind the buttons. Once you break them you…

I had a mission: Customize my Switch and its accessories with the main console's marketing color: Red. Those interchangeable buttons and D-Pad do the job well. They look good and have a velvety finish that won't distract you while gaming. My only complaint is that the ridge that lifts the d-pad off the board is short, meaning the d-pad entries are more prone to unwanted pressure even after some of the contact points have been covered with tape. I need to somehow increase the height of the divot

L+R buttons stick after correct installation. Apparently this was due to two grip points, one that seemed to be due to the mold not breaking properly leaving some excess and the other apparently due to the mold creating a flat edge around the button (the part which will not be). visible after the shell is lit) is too large. The problem was easily solved with sandpaper and a metal file, but for the price of cheap plastic buttons alone I don't think I need to modify it. When I asked a question…

I won't lie, I really like this type of boot when paired with a controller, but there are a few small things I would change. I installed these buttons on a brand new Pro Controller and it is very difficult to open the controller. When I got to the triggers, things got a little more complicated. The ZL and ZR triggers are held to the frame with a small metal bar that holds them in place. Removing this small metal bar without tools is quite difficult, so I recommend having the right tools for it.