🎮 eXtremeRate Black Silver Carbon Fiber Bottom Shell for PS4 Slim Pro Controller - Game Improvement Replacement Parts Back Housing Case Cover for Playstation 4 Controller JDM-040, JDM-050, JDM-055 Review

That's deceptive. It's a matte look but feels very smooth. If you have one of their "soft-touch" faceplates, you expect that feeling. Installation was easy. The original screws fit, only screw in before assembly. Mine fits with no burrs or seams on the edges. The only criticism I would like is the internal cutouts for the LED/USB part. The cut out for the white thin plastic strip is wrong and I had to remove it. Leaving it inside left a gap in the case because it didn't close completely. I just

While fit is not a critical factor, it is far from perfect. How can it be if you buy the top and bottom as a set, but they are sent separately? They could have come from different production runs, which I think mine did. As you can see from the photos the shell does not sit as smoothly as it should. If you look closely you can see that the lines of the image don't match. If you're lucky enough to get the top and bottom from the same production batch, they might be a perfect match, but don't…

This was changed along with the installation of aluminum knobs and joysticks. It doesn't look like it has been deformed due to uneven cooling like some injection molds (I'm dealing with molded foam at work, it seems to go bad). For a proper install, remember to reconnect the lightbar ribbon cable first, then reconnect in the reverse order that you removed the first one and make sure everything snaps into place. Then tighten all the screws, recheck the correct closure and finish tightening the…

This assessment will be similar to the front bezel review. But that's backshell. Something is wrong with the seams, they are very noticeable. There was also discoloration, making the shell stick out. Essentially, the gap is a decent size and taller than the other case. It might not bother you, but it's really not very comfortable to hold in your hands. The seams don't line up and that's because it lifts up when you hold it. Installation is not difficult but can be time consuming when testing…

I really like Extremerate stuff, they have nice skins for DS4 and joycon/console switches which I've used so far. It's a lot cheaper and MUCH more convenient to put a skin on your controller instead of buying a whole new one. First, if you're not very good with electronics or small screws, it might seem a bit complicated, but it's not that bad. difficult. If you have something like an ifixit set or a small bit screwdriver set, get these. Also look for a YouTube tutorial on how to disassemble a…