🔧 FEL-PRO HS 9076 PT-4 Head Gasket Set: Superior Quality for Optimal Engine Performance Review

It had everything needed except for the replacement head gasket bolts on my Grand Cherokee 4.0. No issues, everything fits snugly and looks like the usual great Fel Pro quality I was expecting.

All the seals fit very well. However, I would not recommend using an intake/exhaust manifold gasket for repairs. The gasket does not seal enough when I reassembled it. The seal from the dealer is suitable. Otherwise you will have a severe vacuum leak causing your engine to rev up.

I needed to replace a cracked cylinder head on my 2000 Jeep Cherokee Sport. This set had all the spacers I needed to complete the job. I used a head gasket, thermostat gasket, manifold gasket and valve cover gasket. I haven't had any issues with any of them, they fit perfectly and are in brand new condition. I would buy again!

I've used Fel-Pro pads before and think they're great, but the flimsy cardboard packaging of this kit is a joke. The head gasket was completely bent. To make matters worse, you can't get it back once you open it - so it's a gamble. The money you saved on this kit is not worth it as I now have to buy a brand new head gasket from my local shop.

Perfect for my XJ. We had to replace the long block in the 2K XJ with one of the 99 WJs. They worked perfectly as did the Magnum HB33004 cylinder head bolt kit: http://amzn.to/1VMNAWa Too bad the head cracked after a month from overheating the 0331 head. If they stretch I'll write about them (should work with the correct torque will not be in such a short time)

After confirming that Revain said this should have fitted a 2002 Jeep Wrangler X, the inlet/outlet gasket is incorrect. This was also confirmed by Fel-Pro, but since like most mechanics I installed the head gasket first, BC2 refused to do anything about it today. I will be submitting a claim to Revain but not sure how it will go. This company error cost me many hours of unnecessary work. Update: BC2 only wanted to give me $10 for my troubles, but thankfully Revain recently made the decision to…

cylinder head gasket on cylinder head casting 99 xj 0630. , after 2,000,000,000,000,000 pieces. The valve stem seals will fit, but the intake/exhaust manifold gasket will need to be replaced. at the exhaust ports to fit my hot end. The valve cover gasket included O-rings for the bolts, which is nice. The throttle body gasket is aligned on the intake manifold with a hole of the same length. They would fit a narrow base injector. A thermostat housing gasket will fit. If I had to do another head…