🚽 Fluidmaster PerforMAX Universal Water-Saving Long Life Toilet Flapper for 2-Inch Flush Valves | Adjustable Solid Frame Design | Easy Installation | Red | 1 Pack Review

Just installed it and it works great. She looks just like the one I had. It snaps into place and is easy to install. All I had to do was loosen the clamps on the old one and clip it in place. My old one lasted 10 years. So far I like the serviceability of the Fluidmaster parts. Measurement for 2" drain pipe. I almost bought a 3" as I'm not a plumber and thought it was the size of a plug and no drain hole. I'm glad I saw another review on this or I would have bought the wrong size. Thought I…

Nearly zero experience with any toiletries other than, you know, using them. I was able to install it very easily. I noticed that some toilets don't flush properly. I pulled the flush lever and then it wouldn't go up. I had to hold the lever to get the water out. Well, trial and error proved that I installed it incorrectly. If the chain is too long or not long enough, you will have a bad flush. To fix this, remove the chain from the clamp and position it so there is enough room to pull it all…

This one goes to waste. No matter how I adjust the chain (and I've tried almost every adjustment on it in two hours) With our American standard 1.6 gpf, the Damper on a medium flush just doesn't stay up long enough - and regardless of the min-max setting, it flushes just fine Here's the problem: most guests won't hold it down any longer so it's a waste of money The chain can easily get stuck snagging on a hard plastic element Just a poorly thought out solution.

Thanks to YouTube videos, I've become a real plumber. My fill valve and damper were out of order and my toilet was making a weird, scary noise after every flush. I ordered a full set but the valve that came with the inflation valve wasn't heavy enough to stay down after each use. I was tired of constantly reaching out and squeezing it, so I bought this damper hoping it would be better, and it was. This particular model has a better chain than the one that came with the valve. This one works…

I didn't think that a simple toilet valve could have a design flaw, but unfortunately I found it. This thing snaps into place and attaches to the handle very easily and quickly. Unfortunately, when you squeeze the handle, the arm goes up, the valve goes up, and then stays up. Because the valve levers are hard plastic and not rubber like the rest of the gasket, it won't go off. I've taken it on and off a few times and also adjusted between minimum and maximum fill a number of times and the…

i Completely redesigned Koehler toilet to solve the repeated 2-second phantom flush problem! New overflow pipe, new valve, new damper. All new seals. Flush master kits purchased from Amazon. But the leak survived! After weeks of research and troubleshooting I was completely at a loss. Then I realized I had this valve that was getting thinner and "stickier". It is also made in Mexico. After I installed this, the leaking problem went away on its own. The other two new Flush Master Flappers are…

I have a new standard American toilet (1.6 gallons per flush) with a 2" valve that has been misbehaving. installed several toilets and replaced fill valves on several toilets many times. I replaced the factory valve with this Fluidmaster valve since it was advertised as being adjustable from 1.6 gallons to 3.5 gallons. What a disappointment! First of all, it will NOT deliver a 1.6 gallon flush regardless of the setting. Each setting leads to a complete emptying of the tank. I adjusted it with…