Freud Radius Rounding Quadra Cut 34 120 Review

I have several sizes, I always go for the Quadra-Cut model, worth cutting an expensive piece of wood with a great finish.

Not bad to have. Cuts clean. Used once but plan to use more. Part-time carpenter on weekends, plans to drive a few more miles.

I've used this bit a couple of times while building some picture frames. He is as perceptive and confident as the day he arrived. I am absolutely convinced of Freud's editors. This is the third Freud cutter I have purchased and I am very happy with all of them. I wish I could say the same about some other brands.

I've never used a rounded router bit, in fact it was the third time I've ever used a router bit. It was an extremely smooth and easy cut. The end result didn't even need sanding, it was so smooth. Great product! Ideal for softening the edges of a children's play structure.

I'm a hobby carpenter, but I appreciate quality tools. I use Freud and Whiteside as my top choices for editors because of their consistency. I am currently using many circular and straight cutters for edging and hand routing as ordered. What matters is how long the cutters last when used correctly and so far I've been happy with this cutter. I've made several boards and various edgings out of hardwoods (oak, maple, cherry, and hickory) with my Bosch router and this bit seems to run smoother…

Just finished milling over 40ft of tenon boards and the last board looks as good as the first. I've tried two other brands that burned wood and dulled the drill bit. This is now my favorite brand. I didn't have to babysit a bit. That beat was awesome. Over the years, working with wood has always required me to work slowly and pay attention to the details, but not those details. I saved a lot of time and nerves. Thanks very much!

I love the new Freud Quadra Cut with rounded edges for a smooth and easy cut. I complain that the picture shows a round with a top and bottom shoulder, but that can't be done with the included 3/4" diameter bearing. A smaller diameter bearing (1/2 inch) should be used, but that is not the case included, must be purchased separately I have other Freud router bits that have 1/2" bearings but the Quadra Cut has a 1/4" ID and all the other Freud bearings are smaller than 3/16" id so they won't fit…

I am a hobbyist Woodworkers but I appreciate quality tools I use Freud and Whiteside as my top choices for router bits because of their consistency What matters is how long router bits last with proper use and so far I've been happy with this one I have several with my Bosch router Boards made and various edges with hardwoods (oak, maple, cherry and hickory) and this bit seems to run smoother than most round bit pieces I've used over the years. To keep the edge of the blade clean I turn now…