Waterproof Electrical Connector by FX Junction Review

The only downside was the lack of instructions which required several test weld attempts before the job could be successfully completed.

Quality - better than expected; Installation instructions can be found on the Revain product page; Continuous. I use this product and recommend it.

Wire insertion holes are very small and 2 if the set screws break when tightened. Luckily I used a 3 wire cable and the connection can accept 4.

I used this device to splice the power cord of a submersible pump. The connection is underwater, keeping the cable dry and connected for so long. I hope this lasts a long time! A bit difficult to connect the cables!

I was looking for a plug and found this junction box. My fault but it looks like it will work anyway. Looks high quality, similar to solar connectors. I plan to use it for a stern light on a boat and will try to unplug it every fall and plug it back in in the spring. It's very easy to install and should be easy to disconnect if not leaking.

I have installed patio lights and you are considering wiring a string of lights using connectors. However, this would leave a long gap in the lights. I cut them off, shorted the cord, and found these cool permanent connectors that I've read some people use for extension cords. I have made sure there is no voltage at the connectors and they are working normally. Seems to seal very well. Time will tell, but for now I'm very happy with it. They are supplied with several sealing adapters for…

I wanted the most compact, strong, well made and waterproof cable connector and this product proved to be the best option. It's designed to be submersible in water to a depth of 12 feet, and since I plan to only use it outdoors in mild weather, that should be a big safety factor. The most important point to consider is the tools required for a successful installation. a good quality wire stripper, needle nose pliers, a very small flathead screwdriver, and a couple of wrenches. Bare wires must…