🔌 EWCS Premium Extra Flexible 1/0 Gauge Welding Cable Combo Pack - 25ft Black + Red - 600V - Made in USA Review

I've been using it for a year with no problems even in cold weather. Works well, good quality, I will buy again if necessary. Made in the USA.

This worked great for my project to convert my salt/sand shaker from a gas engine to an electric motor. Great quality, great price. Pass my main harness under my truck. I put them in a plastic wire loom to protect them.

Haven't used the wire yet but I'm going to cut it and put some Anderson plugs in to route the jumper wires and winch. It was packaged well and has very fine threads which gives pretty good flexibility for this gauge of wire. Good rubber jacket. The red wire is a bit faded and pink, but still very acceptable. After you strip it, it wears out a lot because the wire is so thin. No problem if you put a pin or tab there and crimp it.

I use this cable for car radios. It's quite high quality, the only thing that bothered me was the layer of cardboard like material between the shell and the real copper strands, I've never seen this before, but it seems to work pretty well with my stereo. It's a lot cheaper than buying real car audio wiring, which is pretty much the same, just with a more flexible cover. If you are using a system that consumes a lot of power, please purchase this material. I'm sure it's also very good for…

I used this cable to make my own battery cables and upgrade my charging system on my vehicle. I use a high power alternator to support the high power accessories I use. I upgraded the charging system and immediately noticed an increase in generator efficiency. With a large cable and ultra-fine strands, the resistance dropped significantly. I tested the system before and after the update. I decided to use the cable for my amplifiers as well. Easy installation and you don't have to worry about…

I have organized my stock and tools including cleaning and repairs as needed. Looking at my welding equipment I saw that there was a lot to improve including making some new wires. I have a Miller Bobcat 250 on a trailer so I can transport it to where I need to work; and the conclusions to this came from a former 20 year old welder. They were 75 feet long, No. 2, and fitted for farm/ranch work; but I decided to buy a new #1 25 foot hooklink and upgrade it with a better platform and tip. These…