🔔 Ford OEM 9L3Z-13832-A Horn Assembly Review

They look the same in every way, including embossing and shape markings. Plugs into a factory plug and sounds great. One horn died many years ago and the other was dead. I'm pretty sure the door lock was louder at this point. However, I had to reuse the bearing mount as it didn't fit properly. No big deal, otherwise it would have been kicked out. Just swap the horns and you're done.

I bought these for my 2018 Ford F250. They sound and look OEM. They are plug and play, except for the need to use the original bracket. The mount that came with the horns didn't even remotely fit my F250. However, removing the horns and using the original bracket added about 5 minutes to the installation. The horns are attached with 1 nut/bolt each. The sound was "right" from the factory horns. They are worth the money including using the original mount.

Great product. As far as I know, not a cheap fake. up and down. Just plug and play but as some have mentioned I had to bend the bracket in the opposite direction in the middle to keep it from hitting the wall and seating properly. I added some dielectric grease to the joints to repel water. In general though, this is an excellent horn for its price. 10/13/19 *Update. part failed. The horn sounds like a dying duck. Even when I honk, Prius owners laugh. It worked really really well and then just…

Good quality and easy wiring. However, they do not fit the 2005 Ford Tour. As you can see from the photos, the horns and wiring are correct, but the bracket and bracket are not. Note the bolt hole this product has compared to the massive threaded bolt hole found on the truck that came from the factory. This is an important difference if you plan to install it without removing the fender or the entire fender liner. Finally, plan to reuse the mount that came with your truck and just move the…

I have a 2007 F150 Regular Cab Pickup. Those horns looked just like the picture on Revain. The tongue and bolt matched, but the horns had to be bent forward a bit because they hit the side of the engine and part of the radiator. It wasn't difficult for me at all. The metal bracket is solid, but I was able to bend the metal twice with a vise, and the third and final time I just bent it by hand. After this little tweak, they fit perfectly and sounded great. I wish I could give 4.75 stars but I…

Good sound quality. The sound even seems a little better than the original. I have a 2018 F150. The newly fitted horn bracket works but does not fit perfectly. I used an old mount for a tighter fit. However, the connection is on the opposite side of my factory horn! This meant I had to mount on the opposite side of the bracket and then bend the bracket back so I could remount the grille. (Avoid the temptation to just install upside down so the connector is on the correct side. Never install the

Not a direct replacement for the original horn due to the bracket, but I simply reused the old bracket and put new horns on it. Harness/connector was connected and working. My silent horn broke and my kids said my truck sounded like a princess carriage... needed replacing! :) Also the safety factor of people not hearing the beep when needed made me want to fix things. Easy fix as I just got to the horn from the passenger wing. He held the wing cover in place with a bungee while I made the…

Ordered for the 1999 Ford F-150 XLT XCab - 4 stars because it wasn't plug 'n' play, although Revain said it was a fluke.1. The bracket provided is not compatible, so you will need to remove the horns and replace them with the old bracket.2. The old wiring harness does not fit directly, so you will need the suggested 2-wire wiring harness.3. You will also need a whip ball and butt plug end connectors. Each of my original horns had a horn for feeding. Power was supplied by three wires, all hot…