GOOACC 100PCS 7mm 8mm 10mm Subaru Push Type Retainer Fasteners Rivets Clips OEM Upgrade for 90914-0007, 90913-0067 & 90914-0051 + Bonus Fastener Remover - Improved SEO Review

Phillips does not work. They're supposed to loosen when turned counterclockwise, but they don't. That's what I needed most and I won't use them unless I'm pretty sure they won't come out. The largest of the three, designed to fit the tool under the center section, seems to work, although I haven't tried it on a car. I don't need a third

So they were too big for most mounts around the car. I may have been looking for the wrong part but there were several types of bolts included in this kit and most were too big for the mounting holes e.g. glove box, tail light, air intake system etc. Mounting near fog lights/bumper .

I didn't have a couple of clamps on my 2019 WRX, maybe because I drove too deep on the snow or something. In any case, this applies to all types of clips for fenders, fenders, etc. They appear to be of good quality and the fit and finish are almost identical to the ones they replaced. This kit contains more than you will ever need plus a tool to remove them for a very reasonable price.

I removed the bumper from a 2008 Subaru Forester and it was much easier with the tool that came with it. I tended to use large "eyelets" but appreciated different sizes just in case. Have a hammer ready to line up the holes. Bring a set of nuts (8-10mm) for a couple of bumper bolts you're not expecting. Mine may have been fixed this way before I bought it, but there's nothing worse than being in the middle of a project and needing a tool.

clamps offer excellent value for money and make a great replacement for worn and broken Subaru gear. A large quantity is included so should be enough for many jobs. The included clip remover tool was very helpful and worked great. The only thing I did to improve it was smooth the underside slightly so it wouldn't scratch the plastic. The original had sharp, uneven surfaces that needed smoothing and took about 20 seconds to perfect.

I used the GOOACC kit to replace a number of missing brackets on my 2003 Subaru Forester. I replaced the latches in the fender well, choke (radiator support fender) and my air intake resonator assembly on the engine. The clips fit snugly, snapping in and out firmly and holding their assemblies in place. The tops of the clips appear superficially different than the original Subaru clips they replaced, but this does not affect their function.

My Outback is fifteen years old so it has a lot of old worn out clips that have put in 150,000 miles in all four seasons and numerous removals and reinsertions. It's nice to be able to service a car without having to worry about completely removing all the old, brittle plastic clips and simply replacing the old clips with new ones before they break. I don't know how durable they are for several years, but most likely there are enough of them here to outlive the car.

For my 2014 Outback: Part number 90914-0007 - 10mm x 15mm - front bumper cover - check. Correct part number and install; Part number 90913-0067 - 8mm x 10mm - Fender Liners - Inspect. Correct part number and fitment; Pack #3 - Mystery Clips - The page says the correct dimensions for part #90914-0051 should be 7mm x 9mm, but this pack of 30 is 8mm x 9mm - I don't know where they go liner clips even though they are interchangeable with the fender. Glad I only needed the first two sizes but if you