🛵 High-Performance GOOFIT PD24J Carburetor for GY6 150cc ATV Scooter with 157QMJ Engine Review

Replaces the head of the GTS 150 hammer. Fits perfectly, complete with electronic throttle and most importantly a bowl with screws instead of rivets.

This is a great replacement carburetor for cheap Chinese ATVs. If only we could get the fuel so they don't stick together! I use StaBil whenever I can but if you need a carb replacement use this one it has worked great for me.

A great replacement carburetor for your Chinese ATV. Unlike a standard carburetor, this one is fully adjustable and you can remove the float bowl to service the jetting system. The standard block is not adjustable and you have to drill out the float bowl bolts to get to the injectors.

We bought one of the UTV Menards Special for a few thousand. What a mistake. Things never went right. He was dying all the time and driving us crazy. You might as well throw dollar bills out the window. We kicked ourselves for not spending more on a well-known brand UTV. After a little research on the internet we found out that on these cheap cars people change the carburetor and have a much better time. So we found this carburetor and just replaced it with the old one. Fits perfectly and our…

I have a 2020 Amigo scooter which I have been using for 7 months now. I went out to start it and it started briefly and then shut off. I removed the automatic choke and sealed the hole with duct tape. The engine started straight away. Then I changed the throttle but it still won't start. I bought this carburetor that fits without any mods. The engine starts immediately and runs better than the old carburettor if it worked properly. A six month old new scooter should not run with a carb stop. A…

So far so good. I made the decision to buy this carburetor because the reviews talked about the exact same problem I was having. My son got a brand new TAO TAO 150CC ATV for his birthday from East Central Sports in North Branch, Minnesota. This Chinese brand ATV is rubbish. We had 3 carburetor changes within the first month. The workshop simply changed the carburettor and it worked every time. Also, a few months later we had 2 more carburetor changes which only lasted a few months because we…

I've been trying to figure out the settings for these carburetors for a number of years. I'm always wrong I recently bought a new bike and haven't touched that carb and it runs like a champ and has been going 53 miles a day for over 4 months. Then I know my old bike needs one of those perfectly tuned carburetors so I don't have to fiddle with it. I tried replacing the injectors, they were too tight causing the engine to be too lean, like running at high idle. It was 100 x 35. I tried using a…

This was the correct replacement for the carburetor on a 150cc GY6 engine on a Coolster 3150DX-2 ATV. The engine started immediately after replacing the old carburetor. But it doesn't start after a month. I adjusted the idle fuel screw 1 turn and it worked fine for 6 months then same problem until the adjustment worked. I found that the pilot jet was clogged with low quality "tube brass" oxides. not designed to run on gasoline. My claim is based on green oxides all over the idle (and main) jet.

I bought this carburetor mainly because it was cheaper than buying all the parts to restore to original. However, despite the extremely high ratings, my expectations were not that high. I also chose this one because the description says it fits my daughter Buddy 125. This is where the three-star rating comes into play. The carburetor itself is too long front to back, too high and the throttle cable. The bracket/installation is too far apart and the throttle cable screw is too big for the…