Happybuy Single Horn Anvil 110Lbs Cast Steel Blacksmith 🔨 Tool for Sale - Round and Square Hole, Rugged & Durable Review

This anvil is just what the blacksmithing community needs. Affordable 1045 cast steel. Has great rebound, rings like a church bell and still holds up well. Large magnets are required, so take your old speaker or subwoofer apart to blunt the ring and attach to a good base. It's noisy. Remove and round off the horn when you're sure you can get it. Break up the edges with a serrated washer and plan to clean out the hardy hole. The hole is basically useless unless you have a 1 inch round bar that…

See attached photos. Literally just delivered. Just take a look! Only the flat horn was covered. if you can call it covered. As some others have said the weight is not enough, mine is about 3lbs less than 110.2 or whatever was advertised. There are holes everywhere. Some are pretty deep. The round horn has some of the worst pits here, but they're found all over the anvil. I could understand pitting in a used anvil. but it's brand new! The round horn looks welded on. Tell me it's not a hammered…

I've waited a very long time to write this review because I wanted to give a fair review. I tirelessly searched for the anvil, and the longer I searched, the more difficult it became. If you're like me and don't have thousands of dollars to blow on an antique Heybudden anvil, but are on the verge of insanity working with a makeshift anvil-shaped object, then you're reading the right review! This anvil will instantly increase your productivity and make you feel like a real blacksmith! The…