🔥 Premium Hardened Temperature Resistant Makerbot: Unmatched Compatibility and Durability Review

So my very first print. No flow, just a droplet at the end of the nozzle that drags across the bed. Insert my old brass nozzle to make the seal. I was glad I didn't have to clean and reuse mine. I tried the other four with the cleaning needle that came with the 0.04 nozzle printer. TWO, didn't even go in, one went in about 2mm, the other went in about 5mm (the last one shut up for trying to use it. If it was printed for more than a few days then you know , as demanding printers, this dispersion

Replaced the stock nozzle after it got clogged with my Filament HTPLA. I cleaned the extruder well, as well as all the components related to the thread. Installed one of these villains and increased the temperature by 10 degrees since they are made of steel. The quality convinced me. The 3D printer prints this filament so easily I couldn't believe my eyes. It looks like it will hold up (all I use are abrasive threads because I love the added strength of these hybrid threads). Don't even ask…

I bought these and used them for a while but I kept getting printing problems. I tried fixing everything else and then just bought cheap (about 10x cheaper than these) standard bronze extruders and all the problems went away. I've tried printing with them at different temperatures, other troubleshooting methods, etc., but when I got new nozzles to compare, it became clear that this is NOT the size advertised or marked on the extruder itself, which many do causes problems. if this is the size…