🔥 Black Painted Steel Headers Kit for Small Block Chevy, GM F-Body 1982-92, 1-5/8 in Primary, 3 in Collector, Street Performance Review

Not what the picture shows, expect it to be headbutts with elbows and they hit straight down and that's it. I have no titles

They're ok, you get what you pay for, had to grind flanges flat to seal, best finish wasn't the best, plugs are a little heavy too range but ok for first teenager

They have been replaced with cast headers and stock exhaust, head gaskets done, both sides stood in front with no accessories. The passenger side manifold needs to be indexed so that it doesn't hit the kth element, but that there are no cuts or hammers. Fits perfectly

on 1990 Camaro, will not fit. The driver side manifold meets the frame, this requires a torch and pry bar. The passenger side won't work until you remove the steel heater line that runs along the frame and reroute it with a rubber hose. They don't buy unnamed $90 Ebay headers or Summit headers to avoid these very problems. 3 stars instead of one because unlike peaks or unnamed all header studs are accessible and the plug wire spacing looks good.

I bought these to fit my 1985 Iroc-Z Camaro along with the Hedman Y-pipe 17478 to retain the factory exhaust routing. First of all, to address the many reviews I have read here and from other sellers regarding these headers: #1) It is CLEARLY stated that they are NOT painted with high temp paint! YOU MUST REMOVE THEM AND REPAINT WITH A HIGH TEMPERATURE PAINTING! #2) Scratches on the paint where they appeared? See above! I had minor scratches but since I sanded them down and applied high temp…