Header banner
Revain logoHome Page
πŸ”„ heng's jrp1000rc jensen vent operator - upgrade for enhanced seo logo

πŸ”„ Heng's JRP1000RC Jensen Vent Operator - Upgrade for Enhanced SEO Review

3

Β·

Excellent

Revainrating 5 out of 5Β Β 
RatingΒ 
5.0
🌬️ Hood Scoops & Vents, πŸš— Exterior Car Accessories

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ”„ Heng's JRP1000RC Jensen Vent Operator - Upgrade for Enhanced SEO

Details

BrandHeng's
MaterialPlastic
Item Weight0.01 Pounds
Cover IncludedHeng's JRP1000R-C Metal Operator Assembly for Jensen Vents
Model0501.1034

Description of πŸ”„ Heng's JRP1000RC Jensen Vent Operator - Upgrade for Enhanced SEO

Fits Heng's Jensen 14" x 14" vents. 6" arm assembly. Metal construction. Heng's Replacement Operator for 14 Inch Elixir and Jensen vents, without crank handle, 6 Inch arm length. 1 per bag.

Reviews

Global ratings 3
  • 5
    3
  • 4
    0
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 5 out of 5

Perfect fit, easy to install

I was a bit rough with the air vent that came over the air vent on the roof of my 2021 Cherokee Wolf Pup Limited and ripped it off completely. When I bought this item (May 2021) they cost $11.19. I bought two just in case. The replacement process is easy if you're a bit mechanically inclined. It's just removing and replacing a set of Phillips head screws. The new one goes the same way. the old one came out with no instructions, although I'm sure there's at least a youtube video if you're not…

Pros
  • 6" Lever Assembly
Cons
  • Something else

Revainrating 5 out of 5

Excellent replacement handle

Better than the original. The wheel that runs in the vent is metal, not plastic like the original in the camper. The original had to be replaced because. Plastic rotted in the heat SW AZ. It installs easily and is a great product. I recommend it very strongly. It is easiest to have one person on the roof and one person inside to install as you will need to lift the handle, hook it onto the air vent, place the air vent on the hinge and then reattach the handle to close the crank and bolt install

Pros
  • Metalwork
Cons
  • Hard to say

Revainrating 5 out of 5

What I needed: Vent hoods

My only difficulty with this product was not that, it was the design of the vent that I fitted it into. Ventilation hole without removing the entire ventilation hole in the upper part of the residential building; it just wasn't an option! I managed the setup with a Phillips Z head up close and worked blindly under me with just a feel. Installation took about 20 minutes, but eventually the waterproofing was a success. I hope I don't have to do this again. The problem was that the Santa Ana wind…

Pros
  • 1 pc in a bag
Cons
  • Some flaws