HiLetgo 6pcs NTC Temperature Sensor 5K + 10K 1% NTC B3950: Waterproof Probe Thermistor for Accurate and Precise Temperature Measurements - 1M Probe Review

1 out of 5 packs was bad but only needed one. Note that two is one value and three is another, as specified in the declaration. The first set was lost in the mail but turned up stamped because Revane forgot to stamp it.

When placed in a cup of ice water, 3 out of 6 sensors read 20+ degrees above normal. I think it's ok for the money but I would pay the same for 3 workers as I would for 6 and half of them are broken.

Good product. Wanted to use it instead of the temperature sensor in our Vinotemp wine fridge. I couldn't route the cord properly, but it was plugged into the top of the socket, no problem, and I ran the cord straight through the door (just taped over). Very satisfied otherwise our wine cooler would be rubbish.

hours, is it a thermistor and does it work? I'm not sure what this connector is, but it's more or less suitable for 2-pin IDC as well as JST. er, tinker carefully if you don't have space. The coded connector is undesirably bulky since there is no need for an established/polarized connection at the thermocouple resistor. but it's secure if you have enough space around the jumper.

Good product. Wanted to use it instead of the temperature sensor in our Vinotemp wine fridge. I couldn't route the cord properly, but it was plugged into the top of the socket, no problem, and I ran the cord straight through the door (I just taped it over). Very satisfied otherwise our wine cooler would be rubbish.

Damn! I picked up a Koldfront wine cooler from a junkyard that apparently someone just bought and threw away as it's almost brand new. Temp didn't read properly so I took a chance on one of them. It was plug and play and the wine cooler is now up and running - we have a brand new wine cooler for $6!

hm is that a thermistor and does it work? er, tinker carefully if you don't have space. The coded connector is undesirably bulky since there is no need for a matched/polarized connection at the thermocouple resistor. but it's secure if you have enough space around the jumper.