Header banner
Revain logoHome Page
πŸ’§ hm digital triple monitor t fittings: monitor your water quality with ease logo

πŸ’§ HM Digital Triple Monitor T Fittings: Monitor Your Water Quality with Ease Review

3

Β·

Average

Revainrating 3 out of 5Β Β 
RatingΒ 
3.0
πŸ”¬ Substance Analysis Instrumentation, πŸ” Test, Measure & Inspect

View on AmazonView on Π―M

Media

(1)
img 1 attached to πŸ’§ HM Digital Triple Monitor T Fittings: Monitor Your Water Quality with Ease

Description of πŸ’§ HM Digital Triple Monitor T Fittings: Monitor Your Water Quality with Ease

Displays TDS levels of the three sensing points with electrode probes. Comes equipped with Mur-lok Quick-Connect T-fittings (standard is 1/4β€²β€² fittings). Auto-Off function conserves battery power. The unit shuts off automatically after 10 minutes of non-use. Dual Range 0-9990 ppm (From 0 – 999 ppm the resolution is 1 ppm. From 1000 to 9990 ppm, the resolution is 10 ppm, indicated by a blinking β€˜x10’ image.). Factory Calibrated: calibrated with a 342 ppm NaCl solution. Meters can be recalibrated with a mini-screwdriver.

Reviews

Global ratings 3
  • 5
    1
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    1

Type of review

Revainrating 5 out of 5

Nice built in TDS meter for your reverse osmosis system

Installed on the reverse osmosis system I use for my reef tank. The sensors were placed on the raw water lines, the reverse osmosis water lines, and the reverse osmosis/diaeration finished water lines. I had no problems with the installation. The kit includes all the connectors required for installation. All you have to do is cut the existing leads where you want to get a TDS reading and connect the probe connectors. The TDS reading matches that of my portable meter.

Pros
  • Conductivity Meters and Accessories
Cons
  • No power

Revainrating 1 out of 5

The displays are reversed.

The goods were well packed. It is very good. I bought this as Brs Ro/Di systems come with this brand. I connected correctly. Water enters line 1, wastewater enters line 2, purified water exits line 3. I get 70 on line 1, 35 on line 2, 0 on line 3. Lines 1 and 2 should be in reverse order. No fewer TDS can leave the membrane than enter. It works fine and I assume it is correct. If the lines didn't change I would give 5 stars.

Pros
  • Devices for substance analysis
Cons
  • I will write later

Revainrating 3 out of 5

Not waterproof

Seems to be a good little gauge and comes more or less accurately calibrated on arrival. Logo or permanent display of Err. I have another one on the way so I'll see if it's just a fluke. A few things to keep in mind. Because it's designed to measure the TDS of water, it's anything but waterproof. Unfortunately, the length of the probe is quite short. So if you're going to use them near a water point, you'll need to seal them against light splashes and moisture yourself. The top side connector…

Pros
  • Inspect, measure and test
Cons
  • Slightly torn