HM&FC 2" x 50' Black Fiberglass Exhaust Header Pipe Wrap: Ultimate Motorcycle Fiberglass Heat Shield Tape Review

Used for barn fireplace. Reduced the surface temperature from 450F to 200F and allowed the gas to stay hotter to reduce creosote formation where heat loss would add nothing to my building.

Nice slide, after watching the installation video on the internet, instructions are included, but I am better with the video, the slides are very easy to install. There was an extra film after installing the 1.75" brakes on the '02 Sportster.

Well after reading the itchy horror stories here's what I did. There is a pair of elbow gloves for washing dishes 2.00. Put dish soap and hot water in a bucket and let it soak for 12 hours. It made everything so easy. It formed easily, overlapped slightly, and looked bloody killer. I haven't sealed it yet, but damn it.

Delivered as promised, good quality fiberglass but wear gloves and long sleeves and eye protection, lots of loose bits of fiberglass, snags and sticks on everything, very itchy, used to block exhaust heat coming through the floor of the corvette, it kept what it promised, cool floors in the car, i will definitely buy it again!

Super cheap compared to products in store. Well packaged, gloves are included although I have my own. I recommend using leather gloves. After you wrap pipes in latex they tend to crack as it is hard work and fiberglass is not your friend. If you don't want to buy leather gloves, double or triple your hands. I'm sure they will break unless you are a pro at it.

This company delivered a phenomenal product along with truly exceptional customer service! I was completely blown away by the fact that they went above and beyond what was necessary for customer satisfaction and that they were the cheapest product for the range I was asking for. It's funny how good the quality is in their company, the product they offer and they really care about customer satisfaction! Thank you, I will be happy to deal with this establishment again.

This is the perfect addition to my DIY drag tubes! Installation was easy as long as you follow a few key rules to make the process as smooth as possible: 1. Pre-soak the foil - I used an old one-gallon plastic bucket filled with warm tap water. And tossed the whole roll in about 30-45 minutes before I was about to start wrapping. 2. Use gloves when wrapping - I have a word for it, fiberglass. You will tighten this band as tight as you can. So unless you want to force fiberglass on your skin, I…