Holley Electric Choke Kit with Internal Vacuum - Multicolor: Enhanced Performance and Versatility Review

Works great with the 3310 Holly, a center mount float carburetor, secondary vacuum system, single metering block and vacuum vacuum port. Ease of installation.

I'm not a carb lover so the instructions and pictures were fine. I have a complaint that the kit did NOT include the three screws for the final step of attaching the choke cover. You need to pay attention to quality control. A bit disappointed in a big company like Holley.

Ok, in my opinion, the e-choke is much better than the hand choke. You will find that the idle screw is almost impossible to reach. The cork pad is a bad joke at best, and you'll need a surgeon's hands to put it together. Aside from the initial setup, this is a worthwhile upgrade.

Used on a 4 and 2 barrel holly, it worked fine both times, note the instructions say you will most likely be using the original muzzle pad I have took mine off and put a new one on and then had to do it all over again to put the old one on. Enjoy the electric choke.

Good product for a matched Holley 4165 carburettor. It will fit a newer Holley 4165, ok for a few years but not all I have. Be careful what you buy and don't trust descriptions for small details. The backlight is not suitable for holley 4165 models that do not have a stand in the right place.

Saw a review that says it fits there 2300 2 kegs exactly. So I bought it. Because there is no electric choke for the 2300 2 barrel that Holly makes. Although they have the opportunity to come with one. The pressure screw hits the body. There's nothing I can do to make it work. It just doesn't fit this carburetor. Another punch to Holly's teeth. It NEVER ends with carbs. FYI on the quick fuel pick I added spacers and got it to work. It wasn't even possible with what Holly sent me. If you have a…

Replaced the hand throttle on my Holley 3310. I like the simplicity. But I don't like the fact that it starts opening as soon as it gets power from the ignition, so I plan on wiring it across an oil pressure switch so it only gets power when the engine starts. There are a few helpful images in the instructions but a few more could be used. And one thing in particular was a bit inaccurate. The included fast idle lever did not match the part illustration in the manual, so determining its…