Honda Genuine Parts 08P09-T6Z-100: Protect Your Vehicle with Premium Splash Guard Set, 1 Pack Review

Assembly is fairly easy with a suitable screwdriver, screw in the bottom screw first, the factory instructions found on the internet show the correct screw tightening sequence, they look ok but there are small gaps on either side, see fig.

The product is fine but you need a front and rear version. This isn't the vendors fault, but I've done more research than I have. I will follow up after I have installed all 4 correct parts. Hope that helps. take care

Item as described. As many other reviews say, check out the installation instructions on YouTube - very helpful. It took less than an hour to install all 4. Has been installed for a few months now. Fits well. You look good. Recommended - Save money and get them instead of buying from the dealer.

I spent a lot of time removing the factory plugs at the location of the extra screw before realizing that the screw just needs to be screwed THROUGH. don't be like me Looks good, helps reduce deposits, but only by 75%. I wish they were 1 inch wider and longer, maybe better to reduce spatter.

Fenders will fit. The plastic was slightly warped and slightly different in color than the body plastic. If they had come in a pickup, I wouldn't have noticed either. They come with the necessary hardware, but with no instructions, not that you'll need them. I would buy them again.

On closer inspection and without any guidance I looked at the rear wheel well of my 2017 Honda Ridgeline RTL-E and found that using the bolts there already would suffice. WOW, this speed. It changes everything. Installation was easy.

No instructions but easy to find online. The fenders fit perfectly. I made a small installation mistake on the fronts, easy to fix and my mistake, otherwise approx. 25 minutes total installation. You'll probably want to buy a short Phillips head from Depot for about $2 since you have almost no space between the tires and the wheel arch. My short screwdriver was too long. You look good too.

See my review before. Easy installation. Before you dive in, download the guide. You can reach the back of the wheel well to attach the clips. One thing is not clear in the figure. The clip attached to the side of the guard enters the wheel niche, see photo. Press the fender firmly against the wheel arch before tightening any of the bolts. Got a really short Phillips head, it fits snugly.

While no instructions are included, they're fairly easy to find online. The fit is exceptional and installation is easy enough. The downloaded instructions were ok, but could have been better. Advice that will make your life a little easier. Before placing the spring nuts in the right places, use pliers to squeeze them a bit to hold them in place. Mine always wanted to slip. You look great. You won't regret putting them on your Ridgeline.