Header banner
Revain logoHome Page
wanhao flashforge builder hotend nozzle logo

WANHAO FlashForge Builder Hotend Nozzle Review

3

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🖨️ 3D Printer Parts & Accessories, 🏭 Additive Manufacturing Products

View on AmazonView on ЯM

Media

(2)
img 1 attached to WANHAO FlashForge Builder Hotend Nozzle
img 2 attached to WANHAO FlashForge Builder Hotend Nozzle

Description of WANHAO FlashForge Builder Hotend Nozzle

Fits: FlashForge Creator Pro / FlashForge Creator X / FlashForge Dreamer / QIDI TECH I / ​PowerSpec 3D Pro​ / PowerSpec 3D X / PowerSpec Ultra 3D Printer / ​Wanhao Duplicator 4S / Wanhao Duplicator 4X / Wanhao i3 / Monoprice Maker Select 3D Printer v2 / Cocoon Create 3D. Kit Includes: 1 Plated Brass Wear Resistant Nozzle / 1 Thermal tube / 1 Thermal compound. This is a Drop in All Metal Conversion Kit for MK10 Extruders. Made in USA by Micro Swiss.

Reviews

Global ratings 3
  • 5
    2
  • 4
    0
  • 3
    1
  • 2
    0
  • 1
    0

Type of review

Revainrating 3 out of 5

Excellent quality and performance but very expensive.

I've been using them in my Flashforge Creator Pro for a little over 3 years and the performance is great. A must-have upgrade over standard PTFE tube nozzles and much better finished than cheap alternative all-metal hot ends. Finally, I recently had to replace one after a print came loose from the bed, covering my heater block and badly clogging everything with plastic. I really just needed a new nozzle, but regular nozzles don't work - they have an internal cone designed to mate with a thermal

Pros
  • Satisfied so far
Cons
  • I'll write back later

Revainrating 5 out of 5

Great hotend and nozzle but needs tweaking.

It was easy to install if you take your time. I learned the hard way that this doesn't work with stock injectors. After installation, everything needs to be recalibrated, especially temperatures. The instructions state that PLA requires a much higher temperature. I've found that temperatures between 10 and 40 degrees Celsius give excellent results, even with poor quality yarns. I also found that my firmware does not allow operation at higher temperatures. A quick update solved this problem. The

Pros
  • Weight
Cons
  • Some small things

Revainrating 5 out of 5

Great but only for a specific purpose

This all-metal hot end is EXCELLENT when you need to print with high temperature filaments that would otherwise ruin the PTFE tubing in your extruder. However, I recommend that you DO NOT USE THIS FOR PLA PRINTING. There's a reason your 3D printer came with a PTFE hose and not a solid metal tip: it's because the PLA gets too soft to feed properly without it. So if you're primarily using PLA and only have one extruder, don't buy an all-metal hot end. This will jam up your extruder and ruin your…

Pros
  • Absolutely amazing!
Cons
  • Not bad, but...