Header banner
Revain logoHome Page
husky liners 59151 guards wrangler logo

Husky Liners 59151 Guards Wrangler Review

2

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.3
🚗 Mud Flaps & Splash Guards, 🚗 Exterior Car Accessories

View on AmazonView on ЯM

Media

(4)
img 1 attached to Husky Liners 59151 Guards Wrangler
img 2 attached to Husky Liners 59151 Guards Wrangler
img 3 attached to Husky Liners 59151 Guards Wrangler
img 4 attached to Husky Liners 59151 Guards Wrangler

Details

ColorBlack
BrandHusky Liners
MaterialMolded Plastic
Vehicle Service Type2018-2019 Jeep Wrangler Sport, 2018-2019 Jeep Wrangler Sport S, 2018-2019 Jeep Wrangler Unlimited Sahara, 2018-2019 Jeep Wrangler Unlimited Sport, 2018-2019 Jeep Wrangler Unlimited Sport S See more
Fit TypeVehicle Specific Fit

Description of Husky Liners 59151 Guards Wrangler

Our Mud Guards are tailor fit to match your fenders perfectly. Our Mud Guards are built to the maximum width for full tread coverage of factory tires. Durable, impact resistant all-weather thermoplastic material. Designed and manufactured in the USA.

Reviews

Global ratings 2
  • 5
    1
  • 4
    1
  • 3
    0
  • 2
    0
  • 1
    0

Type of review

Revainrating 4 out of 5

Perfect Protection for Off-Road Adventures

After I put it to the test on a muddy terrain, i can say that these mud flaps truly deliver exceptional protection .The installation was easy and they fit perfectly on my Jeep Wrangler. The tough and durable material not only keeps mud and rocks from damaging my car's paint but also enhances its rugged look. However, I noticed that they create a bit of wind noise at high speeds, but it's not a deal-breaker. Overall, I highly recommend this product to any adventurer looking for reliable mud…

Pros
  • Exceptional protection, easy installation, perfect fit
Cons
  • Creates wind noise at high speeds.

Revainrating 5 out of 5

You will need a drill

This is not a mudguard. However, the holes are only for attaching the screws that hold the protective cover to the side. There is an 8 mil bolt in the center. The holes you drill press the outside edge against the rear bumper which is plastic (DO NOT USE A LARGE DRILL). I recommend inserting the screw half-tight to allow the edge to attach, then drilling one hole at a time to make sure the fit is good (don't over-tighten the outer screws), then fully tightening the screw. The only issue I had…

Pros
  • Durable, impact resistant, all-weather thermoplastic material
Cons
  • Damaged