🚽 Danco HYR451T HyrdroRight Universal Water-Saving Toilet Repair Kit: Dual Flush Valve, Lever Handle, White- Maximize Efficiency in Your Toilet! Review

Unfortunately didn't fit our toilet due to the shape of the lid but we installed it and loved it. To be honest, it was ridiculously stupid not to check the seat before all the work was done, but while it didn't look like it protruded past the rim of the tank, the cap is right where the cartridge is , just a tiny bit arched (saves someone a lot I hope). works, but to be honest I think this is a clear flaw in our cover and it appears it will match our other toilets so we're clinging to that). If…

I've since learned how to use the grip and now it works great! To start a quick flush, the handle must be quickly squeezed, not held. Then the water flow is adjusted by the blue float, which can be adjusted. The instructions don't specify how long to hold the button down so it was trial and error. But the block works fine. Before discovering the secret, I called the supplier and explained my problem. Then, without hesitation, their tech support sent me a replacement purge valve assembly. When…

I had the dual flush retrofit version of this competitor's kit and overall I like it better. It's easier to install and more intuitive to save water. In addition, the flush in this case is much more reliable, and the 1/2 flush is more efficient. That being said, I have two minor gripes: (1) You must already have a conventional overflow pipe and gasket in the tank, or you must install one. I no longer had it because a competitor's version completely replaced this part. Not a big deal as it's a…

Approx. BEFORE you buy, check that the 20 or so nozzles under the toilet rim are not blocked. THIS WILL BRIEFLY CHANGE YOUR OPINION ABOUT THIS KIND OF PRODUCTS. I know from experience. I was very upset installing it on a 30 year old toilet. This is a very clean toilet but I didn't realize half the jets were clogged with calcium. When flushing, the water should flow down into the toilet quickly and evenly. 9 out of 20 jets had minimal water flow. With a water-saving flush, the basin was not…

Worked great for about a year; I've never been able to use a half-flush to flush a small amount of toilet paper, but was pleased with the easy installation. I've traded with broken knobs in the past and found that getting the knob and float to sync properly with the throttle was a nightmare. So I liked a system with no dampers - until about 2am. When I woke up I was shocked that I had dreamed of someone doing laundry. It sounded so real, I thought, a sudden gush of water. Then around 5am the…

I am using this to replace my previous Hydroclean model HC660 inflation valve (same supplier bought from Danco, same design) which failed for two reasons: the float was leaking and the valve came loose not immediately when the valve lever was raised. Neither of these failure mechanisms are acceptable for a part that's supposed to last 20-30 years, but that I only installed a few years ago. I wanted to install the dual flush feature that comes with this HYR451T kit. But the dual flush was…

Actually I've been through three of these in a few years. The first was installed by someone other than me and worked fine for maybe two years. I don't remember what broke on it, but something gave way and the lever inside got stuck the entire time, so it wouldn't wash off at all without persuasion. For some reason I didn't think it was a branded warning sign. I just assumed something was wrong with what I had and bought two more; one for each bathroom in my house. Now I'm trying to remember…