🚗 Hyundai Genesis Sedan Front Wing Hood Bonnet Emblem - Genuine New 18.4cm 1-pc (2011-2013) Review

The winged Genesis emblem was a little larger than the original I had on my 2011 Genesis and it looked better! It also arrived earlier than expected. If you don't have pre-drilled holes in the hood, you'll need to cut, sand, or otherwise remove the raised ribs on the back. After that, it was easy to install with the self-adhesive backing. You will spend most of your time deleting the old one if you have one. In general I am satisfied.

Top quality OE. It took some time to measure, measure again and then use tape to mark the exact area to place. The hood wing looks great and really decorates the car. I had to grind down the fender struts (not drill the hood) when it came out, but knew I'd try. An inexpensive way to make your Genesis stand out. I recommend doing both the hood and trunk. Thank you Revain seller!

This was exactly what I needed and it is a genuine factory part. There are two handles on the back that you will need to grind or cut to make them perfectly flat. Once that was done and the old emblem removed, I cleaned up the remaining glue/tape and attached this new emblem to my hood. It looks incredible. If you have any questions about removing the old emblem from the hood, please email me and I will help you. It's very easy.

This product comes with two tabs. They don't fit until at least 2011, which makes sense since the badges were originally the Huyndai badges on these badges, not the Genesis badges, so they might properly fit the models that originally came with that badge. No big deal, just grab the players and rip the tabs to pieces. They break easily. Initially, the store did the same, and when that icon disappeared, I replaced it with this one and did the same. The problem is that after a few years the icons