🚀 Fuel Pump Carburetor Kit for ONAN Engine Model DD11 DD13 DD15 BF BG B43M B48M - Replaces Onan Kit 142-0570 Review

I would give this zero stars if I could. The replacement needle damaged the seat in my carburetor, now the carburetor is fried. What a waste of money on my part.

Everything I needed was included. I do not recommend using kinks in the fuel line as they are very light and flimsy. Poorly finished fuel line. The packaging was fine but the vacuum packaging broke in transit so some parts were loose in the packaging but everything was there.

My carburettor is stamped DD15 from 1979. The kit's float seat had a different thread than stock (metric?) and the float pin was oversized in diameter. All seals, float valve and fuel pump parts worked properly. The engine started for the first time in 15 years with both jets set back 1 1/2 from full seat.

I purchased this kit to rebuild an Onan DD11 carburetor on a 1973 Sears SS16. This kit is pretty much useless unless you need spacers. The main jet where the needle sits doesn't fit the DD11 carburettor, I used my old one. There is also an idle jet that does not fit. It doesn't come with a main fuel jet. But if that were the case, it certainly wouldn't fit either. I used the fuel pump and diaphragm that came with the kit. So far, so good. Its pumping. But I'm keeping my old pump in case it…

I needed this set for my lawn tractor to clear snow. The tractor does not sweep snow. This is a cheap Chinese kit. The pads are good for the price. However, the hard parts are not. The fuel pump is cheaply made, but it works. The spring and washer for the pump were not the same. The spring was too big to not fit properly so I used the original spring. Old parts are also used here, a needle and saddle, a float shaft (the diameter is too large). The fuel line is thin and should not be used…