IJDMTOY Marker Bulbs High Power Review

They fit my 2010 BMW 328i. but I had to use the old screws from the original bracket and the connector kept slipping off. I had to apply some glue to make sure the connector didn't come loose after I put everything back together. It was a small job but when it was finished the angel eyes looked great. I will upload a picture soon. Angel eyes used to be yellowish, but now they are bright white.

They are pretty good but require more work than I thought. First you need to remove the metal from the old lamp lens. Next you need to trim the outer protrusions, depending on what model of car you have. You must also insert the ballast into the fixture before installing the lamps. Use the factory screw with new seals and check polarity before replacing the cap. Both installed in less than 20 minutes of work and cleared my codes. hope they hold up.

Decided to use LEDs instead of halogens because I never want to replace them. The prices are not much higher than high-quality halogen lamps, so it makes sense to use LED lamps. Fits perfectly on a 2006 330i and the blown bulb indicator is off. The light quality is good, not too bright and not too yellow. The only thing I noticed is the flickering when the car starts and you happen to be in front of it. No problem for me, maybe for others.

Terrible product. In the description it says bright white, it seems dull yellow to me. Extremely disappointed. Installation wasn't difficult, it just took a long time. It took me about an hour and a half to remove the tires and fender trim and get to the back corner of the headlight. I only leave them because it's already done but they look like crap and it makes me cringe every time I know how much it cost to install for an almost normal look. Don't buy cheap Chinese

These headlights are not bright at all, I can barely see on the dark road and I have to turn on the high beams and they help hardly. Is it legal? I wouldn't be surprised if someone gets into an accident because it doesn't shine. This is a pending lawsuit. Also, the lamp is too long and the cap/seal that prevents water from entering the lamp cannot be reinserted into the lower beam housing, allowing water to enter and fog the whole thing up. . It took me 45 minutes to an hour for each page, so…

This item works on my 2010 BMW 328i. There is an adapter that needs to be attached in order to be able to connect it to the vehicle. The reason for the 4 stars is because the connection itself was quite weak and kept dropping on bumpy roads. As a result, I had to adjust the wires and tie the zippers a lot. They supply screws and standoffs for installation. DO NOT USE YOUR SCREWS, THEY WILL NOT FIT. BUT you MUST use spacers to get a nice tight fit. In general, everything looked much better in…

They will NOT fit 2007 335i Sedan. To get them to work I had to cut out external mounting holes that were too wide to fit the airtight cover. I then used the supplied spacers (which are threaded to fit those outer holes on the LCI car) with the channel locks to insert them into the correct holes for my car. I still had to use the included shorter screws to install them. I also had to break the spade lugs on the machine because the ones that came with it got lost on the drive. Then one of the…

Attempting to fit a '11 E90 LCI Halogen. All was going well (using the included tripod with factory torx screw) until I plugged the lamp adapter into the car's factory wiring harness. The pins on the female LED adapter harness are too short, so the factory connector will not fit securely. Despite being lit briefly, it looked great - good color and even brightness. I called iJDMTOY and sent a photo of her CS. They tried to see if they had a better adapter but it was the one in the kit. They…